7 -+ E transformation behavior in a Fe-21Mn alloy with different grain size and a Fe-32Mn-6Si alloy with various degrees of wld rolling is investigated and correlated with damping capacity. Effect of microstructure on damping capacity is discussed on the assumption that the capacity is proportional to volume swept by 7 / e boundaries. 1.INTRODUCTION Fe-Mn based alloys have been well known for s...

Grain-boundary relaxation in nanocrystalline Fe was studied by high-resolution transmission electron microscopy HREM , and its effect on plasticity was characterized by nanoindentation. Samples with grain size of 9.8 nm were synthesized by mechanical attrition and subsequently annealed at low temperatures 80 and 100 °C without affecting the grain size. While the hardness is not significantly af...

When a propagating cleavage front encounters a high-angle grain boundary it first penetrates through the grain boundary stably. With increasing penetration depth the resistance of the grain boundary rises, resulting in the well-known R-curve. When the balance between the rates of the energy release rate and the grain boundary resistance is reached, the crack advance becomes unstable and the gra...

We have investigated the propagation of {332}<113> twins in a multilayered Ti-10Mo-xFe (x = 1-3) alloy fabricated by multi-pass hot rolling. The material contains a macroscopic Fe-graded structure (about 130 μm width) between 1 and 3 wt% Fe in the direction perpendicular to rolling. We observe strong influence of the Fe-graded structure in the twin propagation behavior. The propagation of {332}...

Effect of addition of municipal solid waste compost (MSWC) on chromium (Cr) content of submerged rice paddies was studied. Experiments were conducted during the three consecutive wet seasons from 1997 to 1999 on rice grown under submergence, at the Experimental Farm of Calcutta University, India. A sequential extraction method was used to determine the various chromium fractions in MSWC and cow...

The aim of this study was to compare the concentrations of five macroand fifteen microelements in the whole grain of spring lines of emmer, einkorn, spelt and two common wheat cultivars, all grown under identical environmental conditions. All elements were determined by ICP-SFMS analysis. The studied Triticum species differed significantly with respect to the concentrations of P, Mg, Zn, Fe, Mn...

We report the main findings of our work on the behaviour of binary Fe-Cu and Fe-Au model alloys designed to explore routes to create new creep resistant steels having an in-built ability to autonomously fill creep induced porosity at grain boundaries. The alloying elements were selected on the basis of their ability to be brought in supersaturation, their limited or even absent tendency to form...

X-ray absorption fine structure(XAFS) is used to investigate the local structural change of Fe60Cu40 and FegoCu20 with the ball milling time. The XAFS results verify that the solid solution of mechanically alloyed Fe-Cu samples are inhomogeneous. We propose that the bcc to fcc structural transformation of Fe small particles of Fe60Cuq0(160h) is induced by interfacial Cu atoms dissolving in smal...

Micronutrient deficiencies in the diet of many people are common and wheat is a staple food crop, providing a carbohydrate and micronutrient source to a large percentage of the world’s population. We conducted a field study to compare five Canadian red spring wheat cultivars (released over the last century) grown under organic and conventional management systems for yield, grain micronutrient c...

We report the first Fe isotopic anomalies and the first Ni isotopic ratio measurements in presolar SiC grains of separate KJG from the Murchison meteorite. With NanoSIMS, we analyzed Fe and Ni in 37 X grains from Type II supernovae and 53 SiC grains of other types. TheNi/Fe and Co/Fe ratios in grains of all types aremuch higher than in the gas from which the grains are believed to have condense...