This study examined the surface microhardness of four kinds of resin composites with different fillers and resin matrices. Ten specimens of 2 mm thickness and 4 mm diameter of each resin composite were polymerized using a halogen light, a blue light-emitted diode, and a plasma arc unit. Microhardness evaluation was performed at top and bottom surfaces for each specimen using a Vickers microhard...

OBJECTIVES The aim of this study was to investigate microhardness and compressive strength of composite resin (Tetric-Ceram, Ivoclar Vivadent), compomer (Compoglass, Ivoclar, Vivadent), and resin modified glass ionomer cement (Fuji II LC, GC Corp) polymerized using halogen light (Optilux 501, Demetron, Kerr) and LED (Bluephase C5, Ivoclar Vivadent) for different curing times. METHODS Samples ...

This paper identifies and investigates potential sources of measurement error using a prototype of a device for measuring tongue-palate distance, contact and pressure across the whole of the hard palate. The Optopalatograph (OPG) is similar in principle to the Glossometer and similar in configuration to the Electropalatograph. It uses optical fibres to relay light to and from the palate and dis...

A comparison was made of the hardness of Z250 and Esthet-X composites light cured with different light sources. Cavities (3 mm diameter x 6 mm deep) were prepared in 240 bovine incisors. The composite was bulk inserted and light-cured using halogen light, LED or xenon plasma arc (PAC) with different irradiances and exposure times, maintaining the same energy density. The specimens were stored i...

Extensive development of designs and prototyping of energy efficient torchiere systems using compact fluorescent lamps (CFLs) has lead directly to the production of CFL torchieres by a major US manufacturer. This paper compares the electrical and photometric characteristics of one of the new CFL torchieres to standard tungsten halogen torchieres (halogen uplighters). Power assessments and gonio...

The purpose of this study was to assess the effect of light-tip distance on the shear bond strength and failure site of brackets cured with three different light curing units: a high-intensity halogen (Astralis 10, 10-second curing), a light-emitting diode (LED, e-Light, six-second curing), and a plasma arc (PAC System, four-second curing). One hundred and thirty-five bovine permanent mandibula...

We developed a new laboratory polymerizing unit (Twinkle MIII: M3) equipped with different light sources (a metal halide and two halogen lamps) that could illuminate independently. This study introduced the structure of the curing unit and examined the curing depth of a representative indirect composite (Artglass). The composite material was cured with the following modes: 1) M3 - halogen only;...

This study evaluated in vitro the pulp chamber temperature rise induced by the light-activated dental bleaching technique using different light sources. The root portions of 78 extracted sound human mandibular incisors were sectioned approximately 2 mm below the cementoenamel junction. The root cavities of the crowns were enlarged to facilitate the correct placing of the sensor into the pulp ch...

A reduced spatial and temporal coherence light from a halogen lamp is used to copy holographic optical elements, and a maximum diffraction efficiency of 80% is achieved.

Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light cur...