Feasibilities of heat and cold storage technologies for vehicles were discussed for improvement of vehicle fuel efficiency. Energy performance of a plug-in cold thermal energy storage system, in which ice slurry is produced at a stationary chiller and charged into a tank in a vehicle for cabin and cargo cooling, was discussed. Energy balance of the plug-in system was compared with onboard heat ...

A low cost, simple solar heating system consisting of an active collector with an In-Floor Heat Distribution and Storage (IFHDS) system was developed in response to the energy crisis of the 1970s. A two-dimensional finite difference model was developed and used to simulate the performance of IFHDS system cross-sections. Simulation runs were conducted with a steady-periodic model for the tempera...

The concept of heat integration in batch chemical plants has been in literature for more than a decade. Heat integration in batch plants can be effceted in 2 ways, i.e. direct and indirect heat integration. Direct heat integration is encountered when both the source and the sink processes have to be active over a common time interval, assuming that the thermal driving forces allow. On the other...

Recently, a heat source system utilizing a heat storage tank for energy savings in buildings was designed. A heat storage tank is an effective system for solving the qualitative and quantitative differences in the required building energy. On the other hand, the existing design process of a heat storage system is difficult to determine if the air-conditioning time is unclear, and the design in ...

The objective of this study was to determine the influence of storage temperature on the viability and heat resistance of Clostridium sporogenes spores. Spore suspension containing both spores and vegetative cells was divided into 3 groups to be stored at different temperatures of -20 (freezing), 4 (refrigerating), and 25 degrees C (ambient temperature). Samples stored for different times withi...

We present analyses of three families of compressed air energy storage (CAES) systems: conventional CAES, in which the heat released during air compression is not stored and natural gas is combusted to provide heat during discharge; adiabatic CAES, in which the compression heat is stored; and CAES in which the compression heat is used to assist water electrolysis for hydrogen storage. The latte...

Recently, the use of hybrid systems using multiple heat sources in buildings to ensure a stable energy supply and improve the system performance has gained attention. Among them, a heat pump system using both solar and ground heat was developed and various system configurations have been introduced. However, establishing a suitable design method for the solar-assisted ground heat pump (SAGHP) s...

The effect of mild heat fruit pre-treatment on some properties of fresh-cut cantaloupe melon during storage was determined. Whole fruit, previously held at 4 C, was immersed in heated water (60 C) with and without dissolved calcium lactate (1%). Fresh-cut processing was done immediately, either after treatment or after storage at 4 C for 24 h. Headspace gas accumulation during storage indicated...