A high-linearity and high-efficiency MMIC power amplifier is demonstrated adopting a new on-chip adaptive bias circuit, which improves efficiency at the low output power level and linearity at the high output power level automatically. The intelligent two-stage W-CDMA power amplifier using the newly proposed adaptive bias circuit extends the maximum linear output power of 0.6dB and exhibits an ...

Abstract This paper presents a high-power inverted Doherty power amplifier for broader operational bandwidth. After analyzing two operation modes according to the load modulation of the Doherty power amplifier, the inverted Doherty structure was selected. In the design, the load impedances for optimum broadband characteristics at both the back-off and peak power levels. The Doherty power amplif...

— A low power wideband noise amplifier (LNA) for 1GHz to 10GHz wireless has presented for wireless application in this dissertation work. Low power wideband noise amplifier is design by using resistive shunt feedback, current reuse, gain flatting techniques, and inductive feedback technique. The high mobility electron transistors are used to improve the Noise Figure (NF) and scattering paramete...

A 2.4-GHz single-stage CMOS low noise amplifier (LNA) structure with ultra low power consumption is proposed. A current reuse technique is used to decrease power dissipation with increasing amplifier transconductance for the LNA. Thus, the same amplifier transconductance for the LNA will be achieved at decreased power dissipation. Also, due to the use of an inverter-type amplifier which has a s...

The comparator is designed in pipelined ADC. FINFET is the technology which performs the dual gate MOSFET. This thesis focuses on the high-speed design of pipelined ADC. In the meanwhile, we try to minimize the power dissipation as well. In this thesis, A semidigital Gm-based amplifier is proposed for a low-power pipelined analog-to-digital converter (ADC )in HSPICE .And also we compare the pow...

Due to the high increase in and demand for a wide assortment of applications that require low-cost, high-efficiency, and compact systems, RF power amplifiers are considered the most critical design blocks and power consuming components in wireless communication, TV transmission, radar, and RF heating. Therefore, much research has been carried out in order to improve the performance of power amp...

Current RF power amplifier (PA) linearization techniques are presently being investigated to improve PA linearity and power efficiency. One such linearization technique, Cartesian feedback (CFB), makes use of analog feedback to linearize a nonlinear plant (Figure 1). The commanded baseband symbol, I and Q, are compared to the symbol being transmitted by the PA, the baseband symbol is predistort...

A theoretical model for laser cooled continuous-wave fiber amplifier is presented. The amplification process takes place in the Tm 3+ -doped core of the fluoride ZBLAN (ZrF4-BaF2LaF3-AlF3-NaF) glass fiber. The cooling process takes place in the Yb 3+ :ZBLAN fiber cladding. It is shown that for each value of the pump power and the amplified signal there is a distribution of the concentration of ...

We describe a Nd:YAG slab laser master oscillator power amplifier (MOPA) system that has been scaled to 104 W of output power at 1064 nm, single transverse mode. The amplifier system consists of rod amplifiers followed by edgeand end-pumped slab amplifiers. The MOPA output of 104 W was 89% fundamental TEM00 spatial mode with less than 3% depolarization. These results are a key milestone in the ...

This research was to design a 2.4 GHz class E Power Amplifier (PA) for health care, with 0.18um Semiconductor Manufacturing International Corporation CMOS technology by using Cadence software. And also RF switch was designed at cadence software with power Jazz 180nm SOI process. The ultimate goal for such application is to reach high performance and low cost, and between high performance and lo...