Creep response of a full-scale floor system fabricated with composite wood I-joists and oriented strand board (OSB sheathing) was measured for 280 days at sustained uniform loads of 20 psf (0.96 kPa). Creep responses of bare I-joists and 3-joist T-beams with OSB sheathing (glued and unglued tongue and groove sheathing joints) were measured under similar load levels and duration. The creep defle...

Introduction Inertial effects are ubiquitous and unavoidable in stress-controlled rheometry. Many readers of this Bulletin will have seen the kind of phenomena shown in the experimental data of Figure 1. If the fluid is sufficiently viscoelastic, inertio-elastic 'ringing' events (i.e. damped oscillations) are observed in the angular displacement measured at the start of a creep test, as a resul...

The compressive creep deforrn;~tiort microstructure of polycrystalline Ni3AI h:is been observed by transnlission electron microscopy (TEM). ( 1 1 I ) rind ( 110) slip systems have been identified in primary creep. Dissociatiort of edge superparti:~l pairs perpendicular to the slip plane (both { 11 1 ) and ( 110) ) is common in crept specimens. I'he formation of this superdislocation...

In the Present study, attempt will be made to propose a new method for prediction of long-term essential creep of concrete utilizing some short-term creep tests under high temperature. To do so, regarding the similarities between essential creep of concrete and creep in viscoelastic materials, the time–temperature equivalence relation in viscoelastic materials is evaluated for concrete. This re...

One of the yet unresolved engineering problems is forecasting the creep lives of weldment in a pragmatic way with sufficient accuracy. There are number of obstacles to circumvent including: complex material behavior, lack of accurate knowledge about the creep material behavior specially about the heat affected zones (HAZ),accurate and multi-axial creep damage models, etc. In general, creep life...

Destructive testing of creep exposed components is a powerful tool for evaluation of remaining lifetime of high temperature pipe systems. The most common destructive evaluation method used today is uniaxial creep testing. Uniaxial creep tests can produce accurate creep curves but the test method has some drawbacks such as costliness and long testing times. It also demands large sample material ...

A lignin-epoxy resin composite was prepared by blending lignin/wood flour with an epoxy resin and polyamine. The effects of the wood flour on the mechanical, thermal creep, and creep recovery properties, as well as the microstructure of the composite, were studied. Among the mechanical properties, the initial modulus increased with increasing content of wood flour. The glass transition temperat...

During the recent decades, the design and construction of underground spaces into rock salt have been particularly regarded for storing petroleum fluids, natural gas, and compressed air energy, and also for disposing nuclear and chemical wastes. The rock salt hosting such spaces will be subjected to various types of monotonic/cyclic, short-term/long-term stresses during the construction and/or ...