& Experiments and finite difference thermal modeling of the induction-heated tool for end milling of elastomers are investigated. Three sets of experiments are designed to calibrate the contact thermocouple for the tool tip temperature measurement, study the effect of tool rotational speed on induction heat generation and convective heat transfer, and measure the tool temperature distribution f...

in this paper by the introduction of the basic equipment of a solar cooling system, solar hydrogen ammonia refrigeration system as a solar cooling technique will be discussed. using heat collector and absorption refrigeration allows us to use residual heat, for cooling, heating and producing hot water and boiling water .this research focuses on methods of heat transfer from the sun into the gen...

Weakly rotating turbulent Rayleigh-Bénard convection was studied experimentally and numerically. With increasing rotation and large enough Rayleigh number a supercritical bifurcation from a turbulent state with nearly rotation-independent heat transport to another with enhanced heat transfer is observed at a critical inverse Rossby number 1/Roc approximately 0.4. The strength of the large-scale...

In the paper development a method for finding nonlinear heat-conducting characteristics of soil is being presented. Two-layer container complexes have been created, side faces which are thermally insulated so that 1D heat equation can be used. order not to solve boundary value problem with contact discontinuity and lose accuracy method’s solution, temperature sensor was placed at junction two m...

In order to improve the efficiency and rate of heat transfer in heat exchangers, various techniques such as increasing the heat transfer coefficient are proposed. This study is devoted to the investigation of heat transfer coefficient variations due to the addition of CuO, TiO2 and CuO/TiO2 nanoparticles into a shell and tube heat exchanger. CuO/TiO2 nanocomposite was synthesized using mechanic...

in this paper, the conjugate gradient method coupled with adjoint problem is used in order to solve the inverse heat conduction problem and estimation of the time- dependent heat flux using the temperature distribution at a point in a three layer system with none homogeneous boundary conditions. also, the effect of noisy data on final solution is studied. for solving this problem the general co...

in order to examine the laminar convective heat transfer of nanofluid, experiments carried out using silver-oil nanofluid in a concentric annulus with outer constant heat flux as boundary condition. silver-oil nanofluid prepared by electrical explosion of wire technique and observed no nanoparticles agglomeration during nanofluid preparation process and carried out experiments. the average size...