the influence of flour content and immersion time in water on the creep behavior of composites made from high density polyethylene (hdpe) waste and mdf (medium density fiberboard) flour was investigated. mixing was carried out by a twin screw extruder and the sample was manufactured by flat hot press. firstly, the modulus of elasticity and bending strength of various mdf flour-polyethylene comp...

Solder joints are the main weak points of power modules used in harsh environments. For the power module of electric vehicles, the maximum operating temperature of a chip can reach 175 ◦C under driving conditions. Therefore, it is necessary to study the high-temperature reliability of solder joints. This study investigated the creep properties of Sn-3.0Ag-0.5Cu (SAC305) and Sn-8.0Sb-3.0Ag (SSA8...

The tail tendons from wallabies (Macropus rufogriseus) suffer creep rupture at stresses of 10 MPa or above, whereas their yield stress in a dynamic test is about 144 MPa. At stresses between 20 and 80 MPa, the time-to-rupture decreases exponentially with stress, but at 10 MPa, the lifetime is well above this exponential. For comparison, the stress on a wallaby tail tendon, when its muscle contr...

Synopsis: This study presents the experimental results on properties of concrete with replacement of natural aggregate by recycled concrete aggregate (RCA). Experimental data on the creep behavior of concrete mixtures (basic and drying creep) was obtained. The replacement factor of natural aggregate by RCA were 0%, 15%, 30%, 60% and 100%, and the test conditions were 50% RH and 20°C. The result...

The objective of these experiments was to test the hypothesis that the "creep currents" induced by Na loading of single frog atrial cells (Hume, J. R., and A. Uehara. 1986. Journal of General Physiology. 87:833) may be generated by an electrogenic Na/Ca exchanger. Creep currents induced by Na loading were examined over a wide range of membrane potentials. During depolarizing voltage-clamp pulse...

in this article, the effects of adding zn and conducting age hardening treatment on impression creep properties of mg-5%sn alloy have been investigated. the creep tests were carried out using impression creep method in which a cylindrical punch was used to apply the stress in range of 450 mpa < σimp < 270 mpa and at the test temperatures of 150, 175 and 200 °c. the results showed that age harde...

A large number of cyclic torsional shear tests on saturated soft clay under unconsolidated undrained condition have been carried out. The changing law between accumulative generalized shear strains vs. failure numbers has been analyzed and a cyclic shear strength curve has been received based on cyclic torsional shear tests. According to the test results, the criterion of saturated soft clay is...

Native collagen gels are important biomimetic cell support scaffolds, and a plastic compression process can now be used to rapidly remove fluid to any required collagen density, producing strong 3D tissue-like models. This study aimed to measure the mechanical creep properties of such scaffolds and to quantify any enhanced creep occurring in the presence of cells (cell-mediated creep). The test...

The effect of molybdenum (Mo) on the microstructure and creep behavior of nominally Ti–24Al– 17Nb (at.%) alloys and their continuously reinforced SiCfiber composites (fiber volume fraction = 0.35) was investigated. Constant-load, tensile-creep experiments were performed in the stress range of 10–275 MPa at 650 C in air. A Ti–24Al–17Nb–2.3Mo (at.%) alloy exhibited significantly greater creep res...