Development of homogenous metal matrix nanocomposites with uniform distribution of nanoreinforcement, preserved matrix nanostructure features, and improved properties, was possible by means of innovative processing techniques. In this work, Al-SiC nanocomposites were synthesized by mechanical milling and consolidated through spark plasma sintering. Field Emission Scanning Electron Microscope (F...

Mechanical cleavage by Scotch tape was the first method to produce graphene and is still widely used in laboratories. However, a critical problem of this method is the extremely low yield. We have tailored ball milling conditions to produce gentle shear forces that produce high quality boron nitride (BN) nanosheets in high yield and efficiency. The in-plane structure of the BN nanosheets has no...

Plastic deformation of materials occurs by the motion of defects known as dislocations and disclinations. High-resolution transmission electron microscopy was used to directly reveal the individual dislocations that constitute partial disclination dipoles in nanocrystalline, body-centered cubic iron that had undergone severe plastic deformation by mechanical milling. The mechanisms by which the...

This paper proposes a novel chemo-mechanical method to in-situ functionalize carbon nanotubes (CNTs). Ball milling in the presence of ammonium bicarbonate allowed the introduction of amine and amide groups onto the surface of CNTs, resulting in the conversion of the semiconducting behavior of CNTs from p-type to n-type. The corresponding electrical conductivity of CNT increased gradually with b...

We have measured X-ray absorption near edge structure (XANFS) of mechanically alloyed YzFe and YFez system as a fundion of milling time. An amorphous phase is obtained by mechanical alloying for 100 hours in the YzFe system and for 500 hours in the YFez system. In both systems the intensity of Fe Is-4pn transition grows up significantly with increasing the milling time and approaches to that of...

The nanomechanical properties of carbon nanotubes particulate-reinforced aluminum matrix nanocomposites (Al-CNTs) have been characterized using nanoindentation. Bulk nanocomposite specimens containing 2 wt % multiwalled CNTs (MWCNTs) were synthesized by a combination of ball milling and powder metallurgy route. It has been tried to understand the correlation between microstructural evolution pa...

Selective laser melting (SLM) offers significant potential for the manufacture of the advanced complex-shaped aluminium matrix composites (AMCs) used in the aerospace and automotive domains. Previous studies have indicated that advanced composite powders suitable for SLM include spherical powders with homogeneous reinforcement distribution, a particle size of less than 100 μm and good flowabili...

Milling is among machining processes one of the most frequently used, but although milling processes operations are very used in mechanical engineering industries and as a lot of experimental results are available, some essential physical phenomena present difficulties of understanding. Indeed milling is a very complex process with physical interactions between shearing, compression, ploughing,...

in this research, mechanical alloying was used to produce ti-50al, ti-45al-5cr and ti-45al-5w (at%) alloys. the effect of ternary addition (cr and w) on microstructure and production efficiency of tial alloy were investigated. alloying was performed in a planetary mill and the milling time varying from 5 to 70h. the structural evaluation in these powders was done by x-ray diffraction (xrd) tech...

In this study, ultrafine grained 2024 Al alloy based B4C particles reinforced composite was produced by mechanical milling and hot extrusion. Mechanical milling was used to synthesize the nanostructured Al2024 in attrition mill under argon atmosphere up to 50h. A similar process was used to produce Al2024-5%wt. B4C composite powder. To produce trimodal composites, milled powders were combined w...