100-nm-thick Cu layers were grown on MgO(001) substrates by ultra-high vacuum magnetron sputter deposition at substrate temperatures Ts ranging from 40 to 300 °C. X-ray diffraction ω−2θ scans, ω-rocking curves, and pole figures show that layers grown at Ts=40 and 100 °C are complete single crystals with a cube-on-cube epitaxial relationship with the substrate: (001)Cu||(001)MgO with [100]Cu||[1...

Corrosion resistance of zircon reinforced alumina refractories has been carried out through static crucible test. The corrosion measurements with percentage, the penetration depth of molten steel and the microstructure of the refractories were evaluated after soaking 150 h at the temperature of 1500˚C. Results showed that the corrosion resistance of alumina increased by adding 20 wt% zirc...

The major objective in glass tank melters is to optimize the entire process by reducing the maximum temperature of melting, improving refractory performance and/or improving melter fuel efficiency. The required characteristics of refractories used in melters are: thermal shock resistance, corrosion resistance, controlled expansion behavior, low thermal conductivity, and adequate creep resistanc...

The recent discovery of perpendicular magnetic anisotropy (PMA) at the CoFeB/MgO interface has accelerated the development of next generation high-density non-volatile memories by utilizing perpendicular magnetic tunnel junctions (p-MTJs). However, the insufficient interfacial PMA in the typical Ta/CoFeB/MgO system will not only complicate the p-MTJ optimization, but also limit the device densi...

MgO is an important inorganic material, which can be used in many aspects, such as catalyst, toxic-waste remediation agent, adsorbent, and others. In order to make use of MgO, nano-MgO was prepared by ultrasonic method using Mg (CH3COO)2.2H2O as precursor, NaOH aqueous solution as precipitant in this paper. Effect factors on MgO nano-particle size were investigated. Characteristics of samples w...

this new method which is worked out in isfahan university of technology, makes it possible to analyze the phases quantitatively in minerals and powdered materials by x ray diffraction and without any reference material. to identify n unknown phases, n different combinations of phases, from fine and coarse fractions, or etc., must be obtained. amorphous phases should not exist. intensity ratios ...

The promoting effect of niobium in a Li/MgO catalyst for the oxidative coupling of methane (OCM) and for the oxidattve dehydrogenation of ethane (ODHE) has been studied in some detail. it has been found that a Li/Nb/MgO catalyst with 16 wt % niobium showed the highest activity for the C, production in the OCM reaction; the activity at 600 “C was ten times that of the Li/MgO catalyst at the same...

Increasing demands for cement, iron and steel industries for refractories with suitable workability in severe conditions (without any environmental risks), make the refractories’ researches to be an active area. Refractories containing Spinel has been developed with addition of chromia as a substitute in refractories using Magnesite - chromite. In this research, different amounts of Cr2O3 were ...