Tribological conditions can change drastically during heavy loaded regimes as experienced in metal forming; this is especially critical when lubrication can only be applied at the early stage of the process because the homogeneous lubricant layer can break along the die-workpiece interface. In these cases, adopting a constant friction factor for the lubricant-surface pair may not be a valid ass...

We study experimentally the flow of a foam confined as a bubble monolayer between two plates through a convergent channel. We quantify the velocity, the distribution and orientation of plastic events, and the elastic stress, using image analysis. We use two different soap solutions: a sodium dodecyl sulfate (SDS) solution, with a negligible wall friction between the bubbles and the confining pl...

A one-dimensional leakage flow model for two-phase ammonia-water twin screw compressors is presented. The model takes into account viscous and acceleration forces and is based on three conservation equations and on the equation of state for homogenous NHiH20 mixture. The governing equations are solved with a finite difference method. Numerical shooting is used to find such inlet flow velocity a...

This paper develops a model to assess the quantitative effect of entry cost and financial friction on cross-country income and total factor productivity (TFP) differences. The main focus is on the interaction between entry cost and financial friction. The model is calibrated to match establishment-level statistics for the U.S. economy assuming a perfect financial market. The quantitative analys...

The major losses of fluid flow in plastic pipes due to friction are usually few or negligible some cases, and this is the assumption that value factor small (small roughness). This work aimed estimate vs Reynolds number compared against previous data, was estimated using an experimental model consisting a polypropylene pipe with nominal outside diameter 16mm length 8.5 meter eighteen elbows con...

The thermal diffusion factor, aT, for a binary gas mixture is calculated on the basis of nonequilibrium thermodynamics. A new formula for aT is derived and this factor is given for several paris of gases according to this formula.

in this paper, the rolling force and reduction ratio have been investigated in multilayer strip rolling. for this purpose, two different set of multilayers have been selected which are al/st/al and cu/al/cu layouts. at first, the validation of the numerical analysis was performed by using an experimental test. after validation of the numerical results, two set of multilayer layouts were simulat...

Abstract Hybrid nanofluid, which is a combination of Propylene Glycol (PG) – Water (H 2 O) admixture and paraffin wax sand, may be utilized as standby for PG blend in solar thermal framework. Objective this article the exploration dissipative flow propylene-glycol water mixture based hybrid nanofluid by sphere with chemical reaction heat source parameters. MATLAB in-built solver bvp4c to exhibi...

We present a novel theory of mixture transport in nanopores, which represents wall effects via a species-specific friction coefficient determined by its low density diffusion coefficient. Onsager coefficients from the theory are in good agreement with those from molecular dynamics simulation, when the nonuniformity of the density distribution is included. It is found that the commonly used assu...

Lubricin and hyaluronic acid (HA), molecular constituents of synovial fluid, have long been theorized to play a role in joint lubrication and wear protection. While lubricin has been shown to function as a boundary lubricant, conflicting evidence exists as to the boundary lubricating ability of hyaluronic acid. Here, we use colloidal force microscopy to explore the friction behavior of these tw...