We have developed a hygromorphic metal oxide actuator using an electrochemical method to produce a superhydrophilic freestanding nano-capillary forest of titanium oxide with a high aspect ratio (~80). This metal oxide film has an inhomogeneous initial gap at the top and bottom surfaces between the tubes due to flexure during fabrication. The actuation mechanism is as follows. First, when a drop...

Objective(s): Since microbial contamination can reduce the shelf life of the foodstuff and there is a potential for the growth of some pathogen microorganisms, films containing antimicrobial agents were produced, which are also biodegradable. In this study, the effect of 1, 3 and 5% nano-zinc oxide on antimicrobial properties and permeability of poly lactic acid film was invest...

Spray pyrolysis has been used to prepare La0.6 Sr0.4Co0.2Fe0.8O3-δ thin film cathodes for solid oxide fuel cell (SOFC) applications. The films are polycrystalline with nano-meter sized grains and less than 1 μm in thickness. Deposition parameters for film deposition have been established. The ratio of deposition temperature to solvent boiling point is found to be the most important processing p...

Nickel oxide thin film of various preferred orientations was deposited using sol-gel method using solvents including methanol. The resulting film was analyzed using X-ray diffraction (XRD), scanning electron microscopy (SEM), contact angle measurement, and ultraviolet spectroscopy (UV-vis). Antibacterial activities of nickel oxide-based film against gram-negative bacteria (Escherichia coli) has...

Efficient visible light-induced photoelectrochemical oxidation of water was achieved using a tungsten(iv) oxide (WO(3)) film composed of perpendicularly oriented plate-like crystallites, a flake-wall film, prepared on a transparent conductive substrate by controlling anisotropic crystal growth of tungsten oxide hydrate (WO(3).H(2)O) followed by calcination.

Nanocrystalline titanium (iv) oxide paste has been deposited on Fluorine doped tin oxide glass substrate by the blade method. The deposited film was subjected to thermal treatment to obtain an electrode foe a photo-electrochemical cell. The electrode was sensitized with prophyrin dye which was a local dye extracted from carica papaya leaves. Avaspec 2.1 spectrophotometer was used to obtain the ...

A zinc oxide nanorod ammonia microsensor integrated with a readout circuit on-a-chip fabricated using the commercial 0.35 μm complementary metal oxide semiconductor (CMOS) process was investigated. The structure of the ammonia sensor is composed of a sensitive film and polysilicon electrodes. The ammonia sensor requires a post-process to etch the sacrificial layer, and to coat the sensitive fil...

The purpose of this study was to investigate the correlation between corrosion resistance and surface composition of an experimental Ti-20 mass% Cr casting alloy in a saline solution containing fluoride. The alloy had a greater resistance to corrosion in a fluoride-containing saline solution than did commercially pure titanium. However, with confirmed dissolution of titanium and chromium, it me...

The interplay of hydrological, chemical and microbial processes in the formation of iron-rich floating films in aquatic environments at a circumneutral pH The direct contribution of microbial activity to the formation of iron-oxide minerals is difficult to prove in wetlands due to the high reactivity of solid iron phases with different compounds and the variety of redox processes that may occur...

The electrochemical vapor deposition (EVD) method is a very promising technique for making gas-tight dense solid electrolyte films on porous substrates, In this paper, theoretical and experimental studies on the kinetics of the deposition of dense yttria-stabilized zirconia films on porous ceramic substrates by the EVD method are presented, The more systematic theoretical analysis is based on a...