Among the food industries, the dairy industry is considered to be the most polluting one because of the large volume of wastewater generated and its high organic load. In this study, an aerobic membrane bioreactor (MBR) was used for the treatment of wastewater from a large dairy industry and two hydraulic retention times (HRT), 6 and 8 hours, were evaluated. For both HRTs removal efficiencies o...

in the present study, the growth of phospholipids' micelles in canola oil by chemical pretreatment and their separation by using membrane technology was investigated. aqueous solutions of calcium chloride (1% w/w) and edta (150 mm) were added to canola oil miscella before ultrafiltration process. ultrafiltration was conducted by a flat sheet pvdf membrane with two different mwcos (50 kda, m116,...

The performance of a polyamide-based thin film composite reverse osmosis membrane (RO) in a spiralwound element BW3025 (FilmTec) for the recovery of caprolactam from an aqueous solution have been investigated. The experimental tests of the RO membrane were carried out using pure water (permeate from a nanofiltration system), brackish water (2000 ppm NaCl) and caprolactam solution (1000 ppm) and...

A model developed for multicomponent gas separation using hollow-fiber contactors permits simulation of cocurrent, countercurrent, and crossflow contacting patterns with permeate purging (or sweep). The numerical approach proposed permits simulation to much higher stage cuts than previously published work and provides rapid and stable solutions for cases with many components, with widely varyin...

The removal of boron from aqueous solution by direct contact membrane distillation (DCMD) was studied with self-prepared polyvinylidene fluoride (PVDF) hollow fiber membranes in the present work. The effect of pH, boron concentration, temperature and salt concentration of the feed solution on the boron rejection was investigated. The experimental results indicated that boron rejection was less ...

viscosity (µ) and density (ρ) are important physical roperties for analysis of membrane processes performance and for designing a new membrane process. in addition, the energy requirement for fluid pumping is depend on these two physical properties magnitiude. in this study, firstly, the effects of different process factors such as transmembrane pressure (51, 101, 152, 203 and 253 kpa), tempera...

Our objective was to determine if annatto color or bleaching had any influence on ultrafiltration (UF) flux during production of 80% whey protein concentrate (WPC) or 80% serum protein concentrate (SPC). Cheddar cheese whey (18 vats using 900 kg of whole milk each) and microfiltration (MF) permeate of skim milk (18 processing runs using 1000 kg of skim milk each) were produced. The 18 runs were...

Seawater pretreatment by gravity-driven membrane (GDM) filtration at 40 mbar has been investigated. In this system, a beneficial biofilm develops on the membrane that helps to stabilize flux. The effects of membrane type, prefiltration and system configuration on stable flux, biofilm layer properties and dissolved carbon removal were studied. The results show that the use of flat sheet PVDF mem...

A 3-D (3-dimensional) numerical modeling approach to analyze the coupling of mineral scale, concentration polarization and permeate flux was developed and demonstrated for a gypsum membrane scaling test in a plate-and-frame RO membrane module geometry. The impact of concentration polarization on mineral gypsum scaling, and in turn the impact of mineral scale on the concentration polarization fi...

This work has been carried out to evaluate biologically the safety utilization of the byproducts, namely orange peel and permeate and investigate the antioxidant role of them against the oxidative stress in lipid peroxidation induced in adult albino rats by the oral ingestion of CCL . The lipid profile namely total 4 cholesterol, HDL, LDL and triglycerides were performed and the results indicat...