gold nanoparticles were synthesized by chemical reduction of haucl4 inside the pores of a polycarbonate-based membrane followed by dissolving the membrane in dichloromethane and further sonication. sonication time as the main affecting factor on the nanoparticle size was investigated. the characterization by transmission electron microscopy showed the formation of gold nanoparticles with diamet...

The results of the measurements spall strength polycarbonate at a maximum compression stress 0.6 GPa in initial temperature range 20-185 o C are presented. It has been found significant decrease when reached glass transition temperature. strain rates plastic wave determined depending on under single and stepwise shock compression. dependences velocity Us --- mass up stresses to 0.8 different te...

We study experimentally the slow growth of a single crack in a glassy film of polycarbonate submitted to uniaxial and constant imposed load. Flame-shaped macroscopic zones of plastic deformation appear at the tips of the crack and the formation of these plastic zones involves a necking instability. In order to understand the crack growth dynamics, we study first the growth dynamics of the plast...

Three types of filters, silver, polycarbonate, and cellulose, were evaluated for permeability toward poliovirus suspended in water, salt-containing, and proteinaceous solvents. The ability of virus to pass through cellulose filters depended on the suspending medium; virus did not pass through cellulose filters in either water or salt solution, whereas the use of protein solutions increased filt...

In heterogeneous media, the scattering due to interfaces between dissimilar materials play an important role in shock wave dissipation and dispersion. In this work the influence of interface scattering effect on shock waves was studied by impacting flyer plates onto periodically layered polycarbonate/6061 aluminum, polycarbonate/304 stainless steel and polycarbonate/glass composites. The experi...

Cardiopulmonary bypass (CPB) is widely used for cardiac surgery by virtue of its proven safety over the course of its use during the past half century. Even though perfusion is safer, incidents still occur. During the repair of a ventricular-septal defect in an 11-month-old infant, we experienced a critical incident related to the potential hazardous effect of volatile anesthetics on the polyca...

Guards on machine tools are meant to protect operators from injuries caused by tools, workpieces, and fragments hurled out of the machine's working zone. This article presents the impact resistance requirements, which guards according to European safety standards for machine tools must satisfy. Based upon these standards the impact resistance of different guard materials was determined using cy...

INTRODUCTION Endoscopic skull base surgery allows minimal invasive therapy through the nostrils to treat infectious or tumorous diseases. Surgical and anatomical education in this field is limited by the lack of validated training models in terms of geometric and mechanical accuracy. We choose to evaluate several consumer-grade materials to create a patient-specific 3D-printed skull base model ...

In this work; resistive moisture sensors were obtained by dip coating sulfonated polycarbonate (SPC) onto silver interdigitated electrodes. Commercial polycarbonate was sulfonated with acetyl sulphate at two different sulfonation degrees corresponding to 9.0 and 18.0 mole %. Impedance spectroscopy was used to investigate the humidity sensing properties at controlled relative humidity (RH%) envi...

AIM The aim of this study was to evaluate the fracture resistance of various provisional crown materials using an in vitro model test system. METHODS AND MATERIALS In the present study polycarbonate crowns, prefabricated by the manufacturer (3M Polycarbonate Crown), and the temporary crowns, fabricated in the dental laboratory environment, were fabricated using bis-acryl composite (Protemp II...