The analysis of drill cutting angles is important for the design of high-performance drill geometry. The cutting angles along the cutting edge of a drill are determined by the combination of its flute and flank surfaces. This paper examines the analysis of both flute and flank surface models and the evaluation of drill cutting angles. A new mathematical model for an arbitrary drill flute face i...

Drilling is the most frequently employed operation of secondary machining for fiber-reinforced materials owing to the need for structure joining. Delamination is one of the serious concerns during drilling. Practical experience shows that an eccentric twist drill or an eccentric candle stick drill can degrade the quality of the fiber reinforced material. Comprehensive delamination models for th...

A method based on extensive laboratory and field measurements was developed to determine the dependence of specific rock cutting energy (SEc) drilling (SEd) for machines with different operating design characteristics similar breaking mechanics. Laboratory were performed a linear device drill, using measurement system measure electrical power forces force/torque transducers. Field consumption c...

Massive actuator arrays found their applications in robotics, pharmaceutics, aerospace, etc. Compared with electrically and/or pneumatically powered actuator array, hydraulic actuator has the comprehensive advantages of higher force density (i.e. force / actuation area), better controllability, and simpler remote control accessibility. This paper presents approaches to construct and control a m...

Optimization of user controlled parameters for High Intensity Focused Ultrasound (HIFU) is an important factor in reducing total dose delivery time while maintaining treatment safety and effectiveness. I will show that z‐path pattern which employs a middle‐front‐back x‐y plane drill pattern is more effective than possible permutations of the same treatment order, is more effective than other co...

Weight on the bit is accomplished by running in the hole, between the bit and the drill pipe, several lengths of extremely heavy thick-walled pipe, called “drill collars”. Drill pipe may weigh up to 30 kg/m. Drill collars, of larger diameter than drill pipe and of constant diameter throughout, can weigh up to IS0 kg/m. The full hanging weight of the whole assembly in the blocks in the derrick (...

this study evaluated direct drilling planters used for wheat cultivation in khorasan-e razavi province. a randomized complete block design with three replications was used. the treatments were direct drilling of wheat plants into wheat residue using the following direct planters: (1) sfoggia (13-25), (2) baldan (spd3000), (3) tondar (spd 2500), (4) semeato (shm 11/13). the parameters measured w...

PURPOSE To determine whether a wire-guided single drill protocol could be utilized without causing an increase in bone temperature beyond those seen with the traditional techniques of sequential drilling with and without a drill guide. MATERIALS AND METHODS A bovine femoral bone model was used with thermocouples and infrared temperature measurements to record thermal increase of the bone and ...

PURPOSE It is difficult for emergency physicians to plan and execute a disaster medical response drill while conducting their daily work activities. Readily available drill preparation manuals are therefore essential, alongside assessment methods to ensure quality. Here, we propose email text analysis as a manual assessment method, and investigate its validity. METHODS The preparation status ...

The drill makes use of four rods to obtain the full length drill string which allows to reach a penetration depth of 2 meters. The first rod is the real drill tool with sample collection capability; the other 3 rods are extension rods. The real drill tool is installed at the mandrel during launch, the other three rods are stored in a dedicated rod magazine together with a back up drill tool. Al...