A novel test methodology is established to evaluate the strain relief boot on optoelectronic components and optical fiber components by measuring the fiber bend radius in side pull test. The technique is developed for qualifying the boot design rather than for lot testing. The criterion and process are provided.

We have demonstrated a Brillouin fiber-optic gyro that utilizes push-pull phase modulation in the ring cavity to suppress frequency locking. This in-line modulation allows an all-fiber system with optical reciprocity. A tenfold reduction of the width of the lock-in range is observed experimentally.

This is the first part of a two-part article describing the effects of The addition of polymers to a cement matrix can add adding poly(vinyl alcohol) (PVA) to a cement based matrix to irasignificantly to the magnitude of the "adhesion" comprove the bond at the fiber-matrix interface. Two types of fibers were ponent of bond at the fiber-matrix interface. For examused, steel and brass fibers (sim...

introduction radon is a colorless and tasteless gas which exists in most soils. it is a substance that poses a potential risk for lung cancer in case a person is exposed to high levels over long periods of time. the environmental protection agency (epa) estimates that 90% of lung cancers per year are caused by radon. the aim of this paper is to estimate the absorbed doses of 222rn by mcnpx simu...

Fiber-matrix interface bonding is an important area of concern in fiber-reinforced composites because it directly related to the mechanical behavior composites. In this study, interfacial bond properties four types fiber at different curing ages were investigated by analyzing pull-out responses. Special attention was given fiber–matrix behavior, including tensile strength, average equivalent an...

Over the last decade, significant effort has been put into mimicking the ability of the gecko lizard to strongly and reversibly cling to surfaces, by using synthetic structures. Among these structures, mushroom-like elastomer fiber arrays have demonstrated promising performance on smooth surfaces matching the adhesive strengths obtained with the natural gecko foot-pads. It is possible to improv...

Introduction: To evaluate the effects of using sodium hypochlorite irrigant on pull-out bond strength of self-etch and self-adhesive resin cements to dentin. Methods: Sixty intact premolars were decoronated and the root canals were prepared by step-back technique. The teeth were divided into two groups according to the irrigant used during root canal treatment: 5.25% sodium hypochlorite and nor...

The design and characterization of a slow-wave series push-pull traveling wave silicon photonic modulator is presented. At 2 V and 4 V reverse bias, the measured -3 dB electro-optic bandwidth of the modulator with an active length of 4 mm are 38 GHz and 41 GHz, respectively. Open eye diagrams are observed up to bitrates of 60 Gbps without any form of signal processing, and up to 70 Gbps with pa...

acrylonitrile butadiene rubber (nbr) composites are prepared from waste nylon 66 short fiber using a two-roll mill mixer. the effects of fiber content and bonding agent on the mechanical and morphological properties of the composites are studied. the curing characteristics of the composites have been studied by using cure rheometer. the cure and scorch time of the composites decrease while cure...