نتایج جستجو برای: specific draft

تعداد نتایج: 1060002  

2002
Zasha Weinberg Walter L. Ruzzo Rimli Sengupta

2007
RAJESH KRISHNAN

1 Abstract Today most VLSI circuits are built in silicon using CMOS transistors. Developments in design automation and process fabrication have resulted in the progressive increase of the number of transistors per chip and decrease in the size of the transistors. But transistor designers are fast approaching fundamental physical barriers to further size reduction. Thus engineers are looking at ...

2011

Note: This draft Recommendation Statement is not the final recommendation of the U.S. Preventive Services Task Force. This draft is distributed solely for the purpose of pre-release review. It has not been disseminated otherwise by AHRQ. It does not represent and should not be interpreted to represent an AHRQ determination or policy. This draft Recommendation Statement is based on an evidence r...

2004
Seisho Yasukawa

This document presents a set of requirements for Point-to-Multipoint(P2MP) Traffic Engineered (TE) Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs). It specifies functional requirements for solutions in order to deliver P2MP applications over a MPLS TE infrastructure. It is intended that solutions that specify procedures for P2MP TE LSP setup satisfy these requirements. Yasukawa...

2001
Elizabeth Wiebel David Greenberg

2011
Barbara M. Altman

People living with long-term functional limitations are very familiar with the influence of the environment, physical and economic structure, as well as cultural and social attitudes, on their lives. These factors can either restrict or support the individual’s full participation in society or have a neutral impact. Our understanding of disability is difficult because of the influence of these ...

Journal: :Journal of the Textile Machinary Society 1956

A. Nouri,

In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...

A. Nouri,

In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید