A strong strain rate dependence on the crystallographic texture of oxygen-free high conductivity copper is observed and reported for the first time. Two shear compression specimens were deformed at widely different strain rates (0.001 s 1 and 7000 s ) to the same strain, and their textures were determined using orientation image microscopy. By comparing the stress–strain curves and the major te...

This paper contains experimental results of in vitro, uniaxial tension of swine brain tissue in finite deformation as well as proposes a new hyper-viscoelastic constitutive model for the brain tissue. The experimental results obtained for two loading velocities, corresponding to strain rates of 0.64 and 0.64 x 10(-2)s(-1), are presented. We believe that these are the first ever experiments of t...

this paper describes experimental and numerical investigations on two specimens of frames composed of steel reinforced concrete beam and angle-steel concrete column under horizontal low cyclic loading. based on the test results, the relationship curves of the horizontal load-displacement and the failure modes are acquired. meanwhile the hysteretic behaviors, skeleton curves, stiffness degradati...

Modifying stress-strain curves is one of the important topics in mechanical engineering and materials science. Real stress-strain curves should be modified after necking point as stress becomes three-dimensional after creation of throat, and consequently, equivalent stress should be used instead of axial one. Also, distribution of triple stresses across throat section is not uniform anymore, an...

Compressive and tensile properties of a carbon nanotube (CNT) reinforced 2024Al composite are investigated under quasi-static dynamic compression as well tension, along three different directions (extrusion, normal transverse directions). Upon compression, yield fracture strengths the show negligible strain rate effect mechanical anisotropy manifested in compressive stress–strain curves. Fracto...

the brass tubes with foam cores of alsi7sic3, alsi7sic3fe1 and alsi7sic3fe3 were produced as the crush-boxes with circle and square cross-section. then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. the uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...

The lateral confinement of masonry columns using composites have shown to improve their strength and ductility. Although, several research studies were focused on investigating the monotonic compression behaviour confined in past, cyclic characteristics, which are necessary for seismic dynamic analyses, not well investigated. Thus, an attempt has been made experimentally characterise under axia...

This paper describes triaxial compression tests conducted to determine the effect of fiber inclusion on stiffness and deformation characteristics of sand-gravel mixtures. Tested soil was a mixture of Babolsar sand from the shores of the Caspian Sea and Karaj River gravel. Portland cement was used as the cementing agent and fibers 12mm in length and 0.023mm in diameter at 0%, 0.5% and 1.0% were ...

In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...

The main objective of this research was to investigate the effect of material properties, strain-rate sensitivity, and barreling on the behavior of friction calibration curves. The compression tests were conducted to obtain the necessary material properties for the finite element analysis. A series of ring compression tests were then conducted in order to determine the magnitude of the friction...