Super 304HCu austenitic stainless steel containing 2.3–3 (wt.%) of Cu is mainly used in superheaters and reheaters tubing of ultra super critical boilers which operates over 600 ◦C of steam temperature. Tensile tests were carried out on Super 304HCu, using nominal strain rate of 1 × 10−3 s−1, at room temperature, 550 ◦C, 600 ◦C and 650 ◦C. The tensile strength and elongation were found to decre...

In this study, the recovery of strain-hardening rate (RSHR) was discovered for the first time in polycrystalline materials (Ni-Si alloys) that have only dislocation activities during tensile test. Detailed microstructure characterizations show that the activation of dislocations in the secondary slip systems during tensile deformation is the major reason for this RSHR. By taking into account ot...

In this paper the effect of different hardening models in simulating the U-bending process for AA5754-O and DP-Steel, taking a benchmark of NUMISHEET 93 2-D draw bending, has been discussed. The hardening models considered in simulations are: isotropic hardening, pure (linear) kinematic hardening and combined (nonlinear kinematic) hardening. The influence of hardening models on predicting sprin...

This work presents modeling of experiments on a balanced biaxial (BB) pre-strained AA5754 alloy, subsequently reloaded uniaxially along the rolling direction and transverse direction. The material exhibits a complex plastic deformation response during the change in strain path due to 1) crystallographic texture, 2) aging (interactions between dislocations and Mg atoms) and 3) recovery (annihila...

The study reports the mechanical property and microstructure of cold rolled low carbon steel and its work-hardening behavior in the deformation process. The tensile test in room temperature of low carbon steel was implemented for the different cold rolling deformation, the stress-strain curve was draught according to the relationship between strength and deformation and fitted for the polynomia...

Experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304H stainless steel. Three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the DRX critical strain: strongly strain dependent softening by SRX alone with softening kinetics control...

The finite-element method is used to perform an accurate numerical study of the normal indentation of an elastic-plastic half-space by a rigid sphere. The effects of elasticity and strain-hardening rate of the half-space are explored, and the role of friction is assessed by analysing the limiting cases of frictionless contact and sticking friction. Indentation maps are constructed with axes of ...

We present in situ transmission electron microscope tensile tests on focused ion beam fabricated single and multiple slip oriented Cu tensile samples with thicknesses in the range of 100-200 nm. Both crystal orientations fail by localized shear. While failure occurs after a few percent plastic strain and limited hardening in the single slip case, the multiple slip samples exhibit extended homog...

The aim of the present work is to investigate the effects of prestrain and subsequent annealing on tensile properties of commercial pure titanium (CP-Ti). According to tensile test results, yield strength and ultimate tensile strength increase with the increase of prestrain. Elongation and uniform strain decrease linearly with prestrain. In the case of prestrain that is higher than 3.5%, the ma...