This paper proposes an improved control method based on modified Delta-Sigma Modulator (DSM) to enhance transient response and improve harmonic contents of buck DC-DC converter. The main advantages of the proposed method are improving the output voltage frequency spectrum, correction of the output voltage harmonic contents and sideband harmonics, reduction of switching noise peaks at the output...

This work focuses on the modeling and analysis of a Standalone wind-PV Hybrid generation system under different conditions in MATLAB/SIMULINK environment. The proposed system consists of two renewable sources i.e. wind and solar energy. Modeling of PV array and wind turbine is clearly explained. The wind subsystem is equipped of a direct driven permanent-magnet synchronous generator, a diode re...

A digital control algorithm for a current-mode (CM) and a voltage-mode (VM) synchronous buck converter (SBC) is developed. In both cases, the design leads to a stable controller, even for a duty cycle larger than 50%. The desired output voltage and the transient response can be independently specified. Moreover, zero steady-state error in the output voltage can be obtained with the aid of addit...

The DC transfer functions for the buck, boost, and Cuk PWM DC-DC converters in continuous conductionmodearell, l / ( l D ) , and-D/( l -D) respectively, ,where D is the duty cycle. Therefore. it is reasonable to expect that the Cuk PWh4 DC-DC converter circuit [l] can be synthesized by cascading boost and buck converter circuits. The purpose of this paper is to present a systematic and rigorous...

A Power Factor Correction Using singleinductor dual-output buck-boost converter operating in critical conduction mode is proposed in this paper. Each output of the SingleInductor Dual-Output buck-boost converter can be regulated independently by multiplexing a single inductor, Compared with a conventional two-stage multiple-output converter, the singleinductor dual-output buck-boost converter b...

The problem of controlling multiphase synchronous buck power converters is considered. The aim is to regulate the output voltage of the converter and to ensure an adequate current sharing between its different channels. The control law is designed from the large-signal bilinear model (of the whole multichannels converter) using the backstepping technique. The obtained regulator is shown to meet...

This paper introduces an approach to near timeoptimal control for synchronous buck dc–dc converters. The proposed proximate time-optimal digital (PTOD) controller is a combination of a constant-frequency pulsewidth modulation (PWM) controller employing a linear PID compensator close to a reference point, and a linear or nonlinear switching surface controller (SSC) away from the reference, toget...