نتایج جستجو برای: thickness of strips

تعداد نتایج: 21170920  

Journal: :Journal of Applied Physics 2023

Kinetic inductances of superconducting nanostrips with a meander pattern are theoretically investigated based on the London model, and effect current crowding at turns is considered. The complex approach developed for analytical investigation kinetic inductance thin $d<\lambda$ narrow $w\ll \lambda^2/d$ strips, where $d$ strip thickness, $w$ width, $\lambda$ penetration depth. We show that dist...

پایان نامه :وزارت علوم، تحقیقات و فناوری - دانشگاه صنعتی اصفهان 1389

run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...

2010
A. Harb A. N. Pandya

The nose is a common site for basal and squamous cell carcinomas. Surgical excision can leave a defect that is appropriate for reconstruction with full thickness skin grafting. Tie-over dressings have gained popularity in this setting. We propose that steri-strips alone provide the necessary support to facilitate excellent graft take.

, ,

Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...

2004
D. G. Porter M. J. Donahue

Micromagnetic simulation of domain wall motion in thin, narrow strips leads to a simplified analytical model. The model accurately predicts the same domain wall velocity as full micromagnetic calculations, including dependence on strip width, thickness, and magnitude of applied field pulse. Domain wall momentum and retrograde domain wall motion are both observed and explained by the analytical ...

, ,

Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...

H. Ghasemi, M. A. Faghihi Sani, Z. Riazi,

Abstract: The effect of phase development on peel strength of alumina-copper metalized joint has been investigated. The alumina-copper joint was prepared in three stages. The alumina substrate was, first, metalized at 1500°C in H2-furnace by a new formulation. In the second step, a nickel layer was electroplated on the metalized layer with approximately 10µm thickness. Finally, copper strip...

2013
Ahmed Nabih Zaki Rashed

This paper has presented the characteristic impedance and signal propagation delay time for both surface and embedded microstrip lines that comprise a conducting strip line with width w, thickness t of conductivity σ, on a substrate of thickness h, relative permittivity εr, relative permeability sub, on top of an infinite grounded electrode. The strips couples to the ground plane. It is observ...

Journal: :Journal of animal science 1986
P L Hamby J R Stouffer S B Smith

Rambouillet X Finn crossbred wether lambs were evaluated for differences in longissimus muscle cross-sectional area and overlaying subcutaneous adipose tissue thickness resulting from the use of the beta-agonist clenbuterol. Treatment groups received 0 and 2 ppm clenbuterol in the diet for approximately 40 d prior to slaughter. Longissimus muscle cross-sectional area and fat depth over the 12th...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید