Experimental evidence is presented to show that significant rotations of brittle phase inclusions of a Fe-rich intermetallic phase occur during plastic deformation on an Al Mg Si base wrought aluminum alloy. The particle rotations are quantitatively characterized, for uniaxial tension, compression, torsion, and notch-tension test specimens strained to different strain levels. The particle rotat...

Amorphous indium–gallium–zinc-oxide (a-IGZO) thin films were deposited using RF magnetron sputtering on polyethylene naphthalate (PEN) and polyethylene terephthalate (PET) flexible substrates and their mechanical flexibility investigated using uniaxial tensile and buckling tests coupled with in situ optical microscopy. The uniaxial fragmentation test demonstrated that the crack onset strain of ...

This study analyzed uniaxial compression strength over time by preparing a homogel specimen from a bio grouting material, a cement-like form produced by environment-friendly microbial reactions. Among chemical grouting methods, the most commonly used method is the Labile Waterglass method. In this study, the homogel uniaxial compressive strength of Labile Waterglass (LW) injection material and ...

The development of accurate theoretical failure, fatigue, and wear models for ultra-high molecular weight polyethylene (UHMWPE) is an important step towards better understanding the micromechanisms of the surface damage that occur in load bearing orthopaedic components and improving the lifetime of joint arthoplasties. Previous attempts to analytically predict the clinically observed damage, we...

Original scientific paper Rock generally contains various micro-cracks, fissures, pores, joints, and other defects. These defects affect the mechanical properties of rock. In order to clarify the influence of native fissures on rock deformation and failure modes, a laboratory study was carried out using the fissured dolomite, and acoustic wave velocity measurement and natural water absorption t...

Original scientific paper To analyse the influence of joint angle, number and spacing on the strength and acoustic emission (AE) characteristics of rock mass, the uniaxial compression model of rock specimens was established using the micro particle flow PFC2D software platform. The intact rock parameters were determined via trial and error, joints with different angles, numbers and spacing were...

It is crucial to understand the creep behavior of Pb-free solder alloys in electronic packaging. Typical service environments are between 298 and 373K. The thermal mismatch induced stresses acting on solder joints result in extensive rate-dependent plastic deformation. The solder alloy is potentially the weakest component in the electronic package because normal operating temperatures are alrea...