M50 bearing steels were alternately implanted with Ti⁺ and N⁺ ions using solid and gas ion sources of implantation system, respectively. N-implantation was carried out at an energy of about 80 keV and a fluence of 2 × 1017 ions/cm², and Ti-implantation at an energy of about 40-90 keV and a fluence of 2 × 1017 ions/cm². The microstructures of modification layers were analyzed by grazing-incidenc...

Static indentation tests on carbon fibre reinforced laminates have been frequently used in literature to predict the value of penetration energy for the laminate. The mechanical set-up most commonly employed involves the use of indentors of diameter comparable with that of the impactors prescribed from standards for falling weight impact, such as ASTM D3763.The specimen is simply supported usin...

In machining of parts, surface quality is one of the most specified customer requirements. Major indication of surface quality on machined parts is surface roughness. Finish hard turning using Cubic Boron Nitride (CBN) tools allows manufacturers to simplify their processes and still achieve the desired surface roughness. There are various machining parameters have an effect on the surface rough...

Nano-scratch and nano-indentation were used to determine hardness, elastic modulus, adhesion, friction and wear resistance of chromium oxide coatings in air and in water. The friction coefficient is higher in water, compared to air, and it increases with the applied normal load, although there are no obvious differences in hardness and elastic modulus in air vs. water. A higher normal load incr...

In this study, ultrasonic assisted machining (UAM) technique is applied in side-surface milling experiment for glass-ceramic workpiece material. The tungsten carbide cutting-tool with diamond coating is used in conjunction with two kinds of cooling/lubrication mediums such as water-soluble (WS) cutting fluid and minimum quantity lubricant (MQL). Full factorial process parameter combinations on ...

Quantitative understanding of cutting forces under hard turning conditions is important for thermal modeling, tool life estimation, chatter prediction, and tool condition monitoring purposes. Although significant research has been documented on the modeling of forces in the turning operation in general, turning of hardened materials involves several distinctive process conditions, including neg...

17-4ph stainless steel is a martensitic precipitation hardening stainless steel that provides an outstandingcombination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. this valuable alloy is widely used in the aerospace, nuclear, chemical, petr...

It is generally known that the friction and wear between polymers and polished steel surfaces has a special character, the behaviour to friction and wear of a certain polymer might not be valid for a d ifferent polymer, moreover in dry friction conditions. In this paper, the reaction to wear of certain polymers with short glass fibres (polyamide + 20% glass fibres, polyamide + 30% glass fibres ...

In this study, multilayer diamond-like carbon films 1 µm thick with different numbers of repetitions were deposited onto austenitic stainless steel SUS304 substrates using source gases. The influence the gas and difference in number on adhesion strength wear resistance was subsequently investigated. samples subjected to cross-sectional microstructure observations, elemental analysis by glow-dis...