OBJECTIVES To investigate the surface properties (roughness, composition, phase transformation) of monolithic zirconia specimens after dental adjustment procedures (grinding, polishing) and wear simulation. METHODS Zirconia specimens (Cercon base, Cercon ht, DeguDent, G; n=10/material) were successively sintered, ground, and polished with an intraoral polishing kit in a three-step procedure. ...

This pilot study evaluates the surface roughness of monolithic zirconia crowns after chairside polishing by different dental practitioner groups. Four practitioner groups (group I: dental clinical students (n = 6); group II: dentists < 2 years post-qualification experience (n = 6); group III: dentists > 2 years post-qualification experience (n = 6) and group IV: dental technicians (n = 6)) were...

BACKGROUND With the aim of developing methods that could increase the fracture resistance of structurally compromised endodontically treated teeth, this study was conducted to compare the effect of three esthetic post systems on the fracture resistance and failure modes of structurally compromised and normal roots. MATERIALS AND METHODS Forty five extracted and endodontically treated maxillar...

In this study, two types of porous zirconia and dense zirconia were used. The flexural strength of non-layered zirconia specimens and those of the layered zirconia specimens with veneering porcelain were examined. Furthermore, the shear bond strength of veneering porcelain to zirconia was examined. The flexural strength of the non-layered specimens was 1,220 MPa for dense zirconia and 220 to 30...

This study evaluated the effect of mechanical cycling on the bond strength of zirconia posts to root dentin. Thirty single-rooted human teeth were transversally sectioned to a length of 16 mm. The canal preparation was performed with zirconia post system drills (CosmoPost, Ivoclar) to a depth of 12 mm. For post cementation, the canals were treated with total-etch, 3-steps All-Bond 2 (Bisco), an...

PURPOSE All-ceramic abutments are employed increasingly often in implant dentistry for esthetic reasons. In vitro stress testing is required to evaluate the suitability of these constructions, especially in load-bearing posterior regions. The purpose of the study was to assess and compare the fatigue and fracture resistance of one- and two-piece computer-aided design/computer-assisted manufactu...

Nanosized sulfated zirconia with Brønsted acidic sites has been prepared by a simple calcination in the absence of any solvent. XRD patterns reveal that the sulfated zirconia mainly consists of tetragonal crystalline zirconia with average size of about 7 nm, which is further confirmed by TEM images. N2 adsorption data show that the nanosized sulfated zirconia has high surface area (165-193 m2/g...

PURPOSE The aim of this study was to evaluate the influence of resin cement thickness on the microtensile bond strength between zirconium-oxide ceramic and resin cement. MATERIALS AND METHODS Thirty-two freshly extracted molars were transversely sectioned at the deep dentin level and bonded to air-abraded zirconium oxide ceramic disks. The specimens were divided into 8 groups based on the exp...

PURPOSE The purpose of this study was to evaluate the effect of the span length on the fit of zirconia framework fabricated using CAD/CAM system. MATERIALS AND METHODS Abutments for single, 4-unit and 6-unit fixed partial prostheses were fabricated. Ten zirconia frameworks were fabricated for each group. The marginal and internal gap were presented by means of replica technique and measured b...

Production of recombinant antibodies against botulinum neurotoxin is necessary for the development of a post-exposure treatment. CHO-DG44 cells were transfected with a plasmid encoding the light and heavy chains of a chimeric monoclonal antibody (S25) against botulism neurotoxin serotype A. Stable cell lines were obtained by dilution cloning and clones were shown to produce nearly equivalent le...