in this study, the microstructure and properties of foam glass obtained as a result of the interaction of the waste glass with sic as the foaming agent and fe2o3 as the oxidizing agent have been investigated using scanning electron microscopy (sem), as well as three-point bending and pycnometery tests. first, the temperature and optimized amount of sic for making foam glass was determined. the ...

• Bending-shear interaction of stainless steel lipped channels was investigated. FE models were developed for shear, bending, and behaviours. Sections with aspect ratios 1.5 2.0 behave under bending-shear interaction. Codified provisions are too conservative a higher level applied shear force. Proposed equations provide accurate consistent predictions. The response cold-formed channel sections ...

Bending property of Ti-Ni alloy dental castings was evaluated in comparison with that of Co-Cr alloy in a cantilever test. Heat treatment effect on the bending property was also investigated in relation to phase transformation. Ti-50.85Ni (mol%) alloy was used, and the shape of bending test specimens was half-rounded in cross section, 2.0mm in diameter. The bending test was carried out at 310K....

Whole bone bending tests are commonly used in mechanical evaluation of long bones. Reliable information about the midshaft can only be obtained if the bending moment is uniformly distributed along the shaft, and if the distribution of the bending stress is not adversely influenced by rigid clamping of the bone ends. A testing device was developed to determine bending stiffness of long bones in ...

Introduction Ultra-thin chips of less than 20μm become flexible, allowing integration of silicon IC technology with highly flexible electronics. This combination allows for highly intelligent products of unprecedented thinness, flexibility and cost. Examples include sensor systems integrated into food packaging or healthcare and sport monitoring tags as wearable patches or even directly in clot...

Crystals bent to logarithmic spirals have been used in applications where large acceptance of divergent x-rays from a small source is needed [1]. Small acceptances can be easily handled with cylindrically bent crystal. In cases where larger acceptances are needed differential bending may be adequate [2]. However, the largest acceptance is obtained from a flat crystal plate when bent into the lo...

Laser forming is a modern process which is mainly used for forming metals. Different Lasers are used in this regard that includes Nd: YAG and CO2. In this study, forming bi-layer sheets of Aluminum/Ceramic by Laser was investigated. Furthermore, effect of Uniform and Gaussian heat flux distribution in different power, velocity, and beam diameters on bending angle was studied. FEM simulation ind...

The bending modulus of individual carbon nanotubes from aligned arrays grown by pyrolysis was measured by in situ electromechanical resonance in transmission electron microscopy (TEM). The bending modulus of nanotubes with point defects was approximately 30 GPa and that of nanotubes with volume defect was 2-3 GPa. The time-decay constant of nanotube resonance in a vacuum of 10(-4) Torr was appr...