geometric and material nonlinear behavior of slender webs in i-column girders having stocky flanges under the action of combined lateral and axial loads is investigated. interaction curves corresponding to the application of compressive and shear loads at buckling and ultimate stages for both web plates and column sections are plotted. in addition, the effects of flange and web slenderness rati...

It is reported in the published literature that the resonant frequency of a silicon micromachined gyroscope decreases linearly with increasing temperature. However, when the axial force is considerable, the resonant frequency might increase as the temperature increases. The axial force is mainly induced by thermal stress due to the mismatch between the thermal expansion coefficients of the stru...

To realize the stability of the passive magnetic robotic system, a novel combination of permanent magnets is proposed. As we know, a single passive magnetic levitation is impossible to suspend all degrees of freedom of a rigid body; this article researches the combination of multiple passive magnetic bearings by the finite element method (FEM) simulation. Through changing the magnetization dire...

The purpose of this investigation was to design a novel magnetic drive and bearing system for a new centrifugal rotary blood pump (CRBP). The drive system consists of two components: (i) permanent magnets within the impeller of the CRBP; and (ii) the driving electromagnets. Orientation of the magnets varies from axial through to 60 degrees included out-lean (conical configuration). Permanent ma...

To explain the cause of axial rotation in a scoliotic vertebral column, the influence of the gravitation force on a spine with a C-scoliosis has been investigated by means of a mechanical model. In this model the gravitation force takes hold of the three-dimensionally curved vertebral column eccentrically. From these reflections it appears that the axial rotation in the scoliotic spine can be e...

A new axial method for measuring the friction coefficient with the atomic force microscope is given. This axial method requires no calibration steps and is performed simultaneously with a normal force measurement by measuring the difference between the constant compliance slopes of the extend and retract force curves. The algorithm can be applied retrospectively to extract the friction coeffici...

Sudden application of load along a sagittal or coronal axis has been used to study trunk stiffness, but not axial (vertical) load. This study introduces a new method for sudden-release axial load perturbation. Prima facie validity was supported by comparison with standard mechanical systems. We report the response of the human body to axial perturbation in sitting and standing and within-day re...