wind speed is one of the characteristics of wind energy which its data is extracted from meteorological stations. in this study, the data obtained from the weather station in the city eqlid during a ten-year period has been used. weibull distribution was chosen as the best distribution function using fitting tests and estimation of some statistical parameters. the results showed that the averag...

Chip formation during dry turning of Ti6Al4V alloy has been examined in association with dynamic cutting force measurements under different cutting speeds, feed rates and depths of cut. Both continuous and segmented chip formation processes were observed in one cut under conditions of low cutting speed and large feed rate. The slipping angle in the segmented chip was 551, which was higher than ...

The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...

The basic aim of present study is to examine the effect of main friction stir welding (FSW) parameters on the quality of AA 6063 plate welds. Welding of AA6063 was carried out by a vertical milling machine, using different tools with a stationary shoulder and during the welding no external heating system was used. Different welding parameters studied were the tool rotational speed which varied ...

In this research, the effects of the rotational speed, feed rate, tool material and lubricants on the tool life and the hole quality are studied in the frictional drilling of the titanium sheets. The friction drilling tests are performed on a CNC milling machine. Furthermore, 5 specimens are selected and their metallurgical structures are studied. The results show thatamong the input parameters...

In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...

abstract – aluminium 7075- t651 alloys are widely used in the production of light weight structures requiring a high strength to weight ratio and high corrosion resistance. the effect of processing parameters on fatigue life of 7075- t651 aluminium joints produced by friction stir welding was investigated in the present study. welding samples were made by employing rotating tool speed of 770, 9...

the separation of saffron stigmas from fresh flowers is the most important and the most difficult stage of saffron harvesting. saffron production costs are high because this harvesting stage is done by hand and is very time-consuming. one way of preserving the saffron flower is to dry it. the separating of the stigma from dried saffron flowers can then be done at an appropriate time. this study...

In the process of polyethylene extrusion polymer material similar to powder or granule is under compression, melting and transmission operation and on base of special form, extrudate has been produced. Twin-screw extruders are applicable in industries because of their high capacity. The powder mixing with chemical additives and melting with thermal and mechanical energy in three zones (feed, co...