In present study, the two phase flow boiling heat transfer coefficient and pressure drop of R410A, R32 and R290 in microchannels are demonstrated. The experimental data were conducted in horizontal stainless steel tubes with the inner diameter of 0.3 mm and 1.5 mm. The testing conditions were performed with the mass fluxes range from 200 to 500 kg/m2s, the heat fluxes from 10 to 20 kW/m2, the s...

Mixtures of ethylene glycol and water are used in cooling the engines in automotive applications. To avoid the two-phase flow in the engine, the mixture is subcooled in the radiator before entering the engine block. Heat transfer is therefore essentially under subcooled flow boiling conditions. Very little information is available in the literature on the subcooled flow boiling characteristics ...

jet impingement boiling is investigated with regard to heat transfer and pressure drop performance using a novel laser sintered 3D printed jet impingement manifold design. Water was the working fluid at atmospheric pressure with inlet subcooling of 7 o C. The convective boiling performance of the impinging jet system was investigated for a flat copper target surface for 2700≤Re≤5400. The result...

Published studies concerning transport phenomena in micro-channel heat sinks can be divided into those concerning saturated boiling versus those focused on subcooled boiling, with the vast majority related to the former. What has been lacking is a single generalized method to tackle both boiling regimes. The primary objective of the present paper is to construct a consolidated method to predict...

Ahstraet--ln many cooling situations, permanent attachment of fins to heat dissipating devices is undesirable yet htrge mechanical loads, important in reduction of thermal contact resistance, are not permitted. This work considers the interface between a low-force pressed-on fin and a heat source in boiling heat transfer; the thermal contact resistance and how the interface region may be used t...

Experimental study of flow boiling heat transfer in a microchannel array consisting of main channels connected to two auxiliary channels (each) was conducted. A microbubble-excited actuation mechanism, powered by high frequency vapor bubble growth and collapse, was established to create and sustain strong mixing in the microchannels. It was shown to significantly enhance flow boiling heat trans...

Experimental measurements of local heat tra nsfer coefficients and pressure drop are made for forced conv ection boiling and condensation for R134a-oil mixtures inside a horizontal tube. The results are compared with the experime ntal data of pure Rl34a. Average convection boiling and cond ensation heat transfer coefficients decreased about 20% at a 10\ o il mass fraction, and boiling and conde...

Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...

Cooling technology becomes more important because of the increase in heat generation density of semiconductor chips. Boiling and two-phase flow is expected as one of the most effective methods to cool the electronic devices because of its superior heat transfer characteristics. Because the boiling heat transfer depends on the selection of coolant, the development of liquid mixtures and their co...