Yasushi Shibuta*, Shigeo Maruyama Department of Materials Engineering, The University of Tokyo 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan Department of Mechanical Engineering, The University of Tokyo 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan Abstract The effect of the substrate on catalytic metal clusters in nucleation process of single-walled carbon nanotubes was studied by classical mo...

Amorphous hydrogenated carbon films were prepared by hot filament Plasma Enhanced Chemical Vapor Deposition using acetylene as precursor. NiP-coated Al substrate was sputtered with thin layer of ruthenium film prior to carbon deposition for its impact on carbon film growth. Film thickness measured and fitted using X-ray Reflectometry showed carbon film growth is an exothermic reaction with appa...

Biodiesel-derived glycerol is a promising substrate for mixotrophic cultivation of oleaginous microalgae, which can also reduce the cost of microalgal biodiesel. The objective of this study is to investigate the potential of using glycerol and glucose as a complex carbon substrate to produce microalgal biomass and biochemical components, such as photosynthetic pigments, lipids, soluble carbohyd...

The effect of mass transport on the growth characteristics of large-area vapor-grown carbon nanofibers (CNFs) was investigated by adjusting the substrate deposition angle (α). The catalyst precursor solution was coated onto one side of a 2D porous carbon paper substrate via a decal printing method. The results showed that the CNFs were grown on only one side of the substrate and α was found to ...

Soil carbon (C) storage is dependent upon the complex dynamics of fresh and native organic matter cycling, which are regulated by plant and soil-microbial activities. A fundamental challenge exists to link microbial biodiversity with plant-soil C cycling processes to elucidate the underlying mechanisms regulating soil carbon. To address this, we contrasted vegetated grassland soils with bare so...

   Electrochemical performance of binary and ternary oxides composed of Ni, Co and Cu produced over a 3-dimensional substrate of vertically aligned carbon nano-tubes (VACNT) as electrodes for aqueous energy sources, is reported and compared in this paper. VACNTs were fabricated inside a DC-plasma enhanced chemical vapor deposition chamber and composite materials fabricated by thermal decomp...

The vapor deposition of open-networked carbon nanostructures and carbon nanotubes (CNTs)-reinforced composites have been developed and studied parametrically. Carbon nanostructures, including nano-tubes, nano-foams, nanoparticles, and nano-walls, have been deposited on catalyst-assisted substrates using microwave plasma electron cyclotron resonance-chemical vapor deposition (ECR-CVD) system at ...

a simple chemical vapor deposition technique at atmospheric pressure (apcvd) is adopted to synthesize the aligned arrays of functionalized multi-walled carbon nanotubes (amwcnts) without using any carrier gas, at 230◦c, 750◦c and 850 ◦c. camphor (c10h16o) is used as carbon source because this botanical hydrocarbon is chip and abundant which convert the cvd technique to a green method for produc...

Different amounts of nanoclay were incorporated into the acrylic resin matrix at 0, 1, 3, and 5 wt.% loadings. The coatings were applied on low carbon steel plates. Optical microscopy, sedimentation test, transmission electron microscopy, and X-ray diffraction were employed to investigate the dispersion of nanoclay in matrix. The corrosion resistance of coatings was evaluated by electrochemical...