In cookware industry, interior spray coating process is an important process to protect the cookware product from the corrosion. In this process, the coating material “TEFLON” is used to spray to cover all the part’s surface. If a pot or pan is not too deep, one spray gun is enough to spray to cover all the interior surface. However, for the high side-wall pot, two spray guns must be used to sp...

Preparation of microfibre constructs of collagen by electrospinning has been problematic due to the instability of collagen in volatile solvents, such as 1,1,1,3,3,3-hexafluoro-2-propanol, so that electrospinning leads to a substantial amount of gelatin fibres. In the present study we have demonstrated the production of collagen-based microfibre constructs by use of a layer-by-layer coating pro...

respectively. It has been reported that coating of a thin MgO layer on SnO2 particles results in enhancement of both solar cell performance and catalytic activities. The promoting effect of MgO layer was owing to barrier effect where MgO acts as a barrier layer for charge recombination. We noticed negative shift of flatband (FB) potential of SnO2 with the increase of pH values and coating of a ...

Tightly bonding of bioactive coating is the first crucial need for orthopaedic implants. This study describes a novel and convenient technique to prepare bioactive coating with high adhesion on orthopaedic substitutes made of polymeric matrix. Here, a chemical corrosion method has been adopted to fabricate a coating on the surface of injection-moulded polyamide66 (PA66) substrates by corrosive ...

The fabrication of multi-level SU-8 microstructures using multiple coating and exposure steps and a single developing step has been achieved for up to six layers of SU-8. Alternating layers of SU-8 2010 (thin) and SU-8 2100 (thick) photoresist films were spin coated, followed by soft-bake, ultraviolet (UV) exposure and post-exposure bake steps. The multiple SU-8 layers were simultaneously devel...

In this work, the hydrophobic modification of TiO2 nanoparticles (HTiO2) was carried out by reacting with dodecylphosphonic acid (DDPA) and hexylamine solution. A facile approach of the self-assembly technique was used for the coating of hydrophobic HTiO2 layer over the microporous polypropylene (PP) membrane. The self-assembled layer was formed between the interface of trimesoyl chloride (TMC)...

Ł. Jamrozowicz, J. Zych, J. Kolczyk, AGH University of Science and Technology, Faculty of Foundry Engineering, Kraków, Poland Investigation results of the drying rate of the selected protective coatings (water and alcohol) are presented in the article. Coating drying rate was determined for the first and second layers. The coating was applied to moulding sand cores. The rate of drying coatings ...

in this article, failure and fracture mechanisms in an aluminum alloy (which has been used in diesel internal combustion engines), with and without ceramic thermal barrier coatings, have been investigated under isothermal and non-isothermal fatigue loadings. in this research, the base material is an aluminum-silicon-magnesium alloy and the thermal barrier coating includes a metallic bond coat l...

This paper presents the coating thickness effect on the stress distribution of a coated cylinder head. A typical thermal barrier coating was applied on a diesel engine cylinder head. Thus, the residual stress which occurred during the plasma thermal spraying was also considered. The coating system consisted of two layers a metallic bond coat and a ceramic top coat. The bond coat thickness is co...