نتایج جستجو برای: combustion parameters

تعداد نتایج: 606823  

2015
Weibo Chen Guixiong Liu

The characteristics of the combustion temperature, flow velocity, CO distribution and NOx emissions of a 10 MW gas burner at different primary to secondary air ratios are numerically studied using computational fluid dynamics software Fluent. The results indicate that the primary to secondary air ratio in gas burner determines the combustion quality through influencing some parameters directly,...

2010
M. Bidarvatan M. Shahbakhti S. A. Jazayeri

Homogenous Charge Compression Ignition (HCCI) engines hold promise of high fuel efficiency and low emission levels for future green vehicles. But in contrast to gasoline and diesel engines, HCCI engines suffer from lack of having direct means to initiate combustion. A combustion timing controller with robust tracking performance is the key requirement to leverage HCCI application in production ...

Journal: :iranian journal of science and technology transactions of mechanical engineering 2015
m. mansoury s. jafarmadar s. m. lashkarpour m. talei

in the present work, the simultaneous effects of fuel injection rate and injection of air jet into the combustion chamber on exhaust emissions, combustion process and performance parameters in a direct injection diesel engine were investigated. in order to create an air jet, a design was presented in which a secondary chamber (air cell) was created inside the cylinder and was joined to the main...

Journal: :روش های عددی در مهندسی (استقلال) 0
محمدعلی گلعذار m.a. golozar

0

In internal combustion engines, exhaust valve and its seat gain considerable temperature as the hot gases exit through them. So, the rate of heat transfer should be under control. In this study, the contact heat transfer coefficient has been estimated. An experimental study on an Air-Cooled internal combustion engine cylinder head has been considered. Using the measured temperatures of sensors ...

A. Paykani, A.H Kakaee, P. Rahnama,

In this paper, a numerical study is performed to provide the combustion and emission characteristics resulting from fuel-reactivity controlled compression ignition (RCCI) combustion mode in a heavy-duty, single-cylinder diesel engine with gasoline and diesel fuels. In RCCI strategy in-cylinder fuel blending is used to develop fuel reactivity gradients in the combustion chamber that result in a ...

2011
Jerzy Kowalski

The calculation of the changing of the combustion mixture composition during the combustion process of the CH4 is presented of the paper. Correct calculation results of the mixture composition during the combustion process in combustion chambers of internal combustion engines is important to define the heat release calculation, modeling and simulation of the combustion phenomena. The paper pres...

2014
Daisuke Nagai Takafumi Akamatsu Toshio Itoh Noriya Izu Woosuck Shin

A thermoelectric gas sensor (TGS) with a combustion catalyst is a calorimetric sensor that changes the small heat of catalytic combustion into a signal voltage. We analyzed the thermal balance of a TGS to quantitatively estimate the sensor parameters. The voltage signal of a TGS was simulated, and the heat balance was calculated at two sections across the thermoelectric film of a TGS. The therm...

2011
Joseph D. Miller Chloe E. Dedic Terrence R. Meyer

Introduction In an effort to reduce pollutant emissions and increase energy efficiency, current clean combustion devices rely on precise control of reaction parameters such as fuel injection rate and reactant mixing. In order to understand, and predict, the effect of these parameters on the overall combustion process, temporallyand spatially-resolved measurements of key thermodynamic properties...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید