Electrical resistivity measurement of freshly prepared uncured and cured soil-cement materials is done and the correlations between the factors controlling the performance of soil-cement and electrical resistivity are discussed in this paper. Conventional quality control of soil-cement quite often involves wastage of a lot of material, if it does not meet the strength criteria. In this study, i...

The flexural behaviour of concrete containing Foamed glass as partial replacement of coarse aggregate is investigated. The coarse aggregate was replaced with 0%, 25%, 50%, 75% and 100% Foamed glass. All other constituents were maintained the same. Reinforced concrete beams were cast using 2 bars of 8mm in diameter in the tensile zone. The density and compressive strength of concrete decreased a...

In this study, bulk ultrafine-grained and micro-crystalline cobalt was prepared using a combination of high-energy ball milling and subsequent spark plasma sintering. The average grain sizes of the ultrafine-grained and micro-crystalline materials were 200 nm and 1 μm, respectively. Mechanical properties such as the compressive yield strength, the ultimate compressive strength, the maximum comp...

An investigation was conducted to determine the influence of recycled scrap tire rubber on the engineering properties of controlled low strength material (CLSM). With control over the ultimate compressive strength of CLSMs being key for applications such as backfilling utility trenches where re-excavation is often necessary, incorporation of scrap tire rubber into the CLSM mixture is a viable w...

statement of the problem : in clinical situations, calcium-enriched mixture (cem) comes into direct contact or even mixes with blood during or after placement. purpose: the aim of this study was to evaluate the effect of blood contamination on the compressive strength of cem. materials and method: three experimental groups were included in this study. in the first group, cem was mixed with dist...

background and aims. polymethyl methacrylate, pmma, is widely used in prosthodontics for fabrication of removable prostheses. this study was undertaken to investigate the effect of adding silver nanoparticles (agnps) to pmma at 2% and 0.2% concentrations on compressive and tensile strengths of pmma. materials and methods. the silver nanoparticles were mixed with heat-cured acrylic resin in an a...

background and aims. although microwave irradiation has been used for disinfection of dental stone casts, there are concerns regarding mechanical damage to casts during the process. the aim of this study was to evaluate the effect of microwave irradiation on the compressive strength (cs) and diametral tensile strength (dts) of stone casts. materials and methods. in this in vitro study, 80 cylin...

introduction: the aim of this study was to evaluate the effect of adding propylene glycol (pg) to mineral trioxide aggregate (mta) liquid with volume ratio of 20% on the compressive strength (cs) of mta in two time periods (4 and 21 days) after mixing. methods and materials: four groups of steel cylinders ( n =15) with an internal diameter of 3 and a height of 6 mm were prepared and mta (groups...

The compressive properties of human enamel and dentin have been reported by Stanford, Paffenbarger, Kumpula, and Sweeney.' The elastic modulus of occlusal, side, and cusp enamel was reported to be 1.8, 6.0, and 8.2 X 106 psi, respectively. The corresponding values for the proportional limit were 16,800, 21,000, and 34,200 psi and, for the compressive strength, 19,400, 28,300, and 40,200 psi. An...

Waste management is becoming a major issue for communities worldwide. Glass, being nonbiodegradable, is not suitable for addition to landfill, and as such recycling opportunities need to be investigated. Due to the high material consumption of the construction industry, the utilisation of waste glass as a partial replacement for fine aggregate in structural concrete is particularly attractive. ...