This paper demonstrates the advantages of extending the scope of prototyping to the requirements capture phase of a project. Prototyping has long been used to elicit users’ responses to ready-formed designs (Boehm, 1988), but only recently has the use of concept demonstrators (Sanderson, 1997) and early throw-away prototypes (Smith et al., 1990) been suggested as a means to capture response to ...

The improvement in reverse recovery of power NPN bipolar transistor (BJT) through incorporation of ‘‘universal contact’’ in the base is studied in detail. It is shown that use of universal contact allows redistribution of base current in saturation from collector region where recombination lifetime is high to extrinsic base region where effective recombination lifetime is low. The reverse recov...

This paper presents finite element analysis of the strength of roadheaher conical picks. Failure forms of conical picks are investigated, and the FE model of conical pick is established which is based on ANSYS. The static analysis is carried out according to the load calculated by empirical formula and the deformation map and stress distribution is obtained. The results show that the maximum st...

Ti conical island structures were fabricated using photolithography and the reactive ion etching method. The resulting conical island structures were anodized in ethylene glycol solution containing 0.25 wt% NH4F and 2 vol% H2O, and conical islands composed of TiO2 nanotubes were successfully formed on the Ti foils. The conical islands composed of TiO2 nanotubes were employed in photoelectrodes ...

In this paper, crashworthiness characteristics of conical steel tubes stiffened by annular rings and rigid polyurethane foam are investigated. For this purpose, wide circumferential rings are created from the outer surface of the conical tube at some determined areas along tube length. In fact, this method divides a long conical tube into several tubes of shorter length. When this structure is ...

A solar absorption icemaker was designed. It is an intermittent system and uses Calcium Chloride and Ammonia as absorbent and refrigerant respectively. The single glazed collector/absorber/generator unit uses a plane glass sheet as the outer cover. Overall collector plate exposed area is 1.0m. A thermodynamic simulation of the icemaker has been performed in order to investigate the effect that ...

A system is being tested for recovery of rf power by conversion to DC pulsed power. The system consists of a cyclotron autoresonance accelerator (CARA) [1,2], and a single stage depressed collector (Fig. 1). A 50 kV, 5 A electron beam is injected into CARA, and up to 1 MW of S-band rf power is absorbed by the beam with efficiency exceeding 95%. The beam then passes to a single stage depressed c...

A finite element analysis is presented for sloshing and impulsive motion of liquid-filled conical tanks during lateral anti-symmetric excitation. The performed analyses led to the development of a number of charts which can be used to identify the natural frequency, the mode shapes of conical tanks for both fundamental and the cos(θ)-modes of vibration. Conical tank geometry was described with ...

in this study, the possibility of producing coal with less than 11% ash from tailings of flotation process was investigated. the effect of six flotation parameters: collector type, collector consumption, frother type, frother consumption, pulp density and mixing rate were studied on a sample from a tailing dam. a software based experimental design approach (dx7) was applied to determine and mod...

The possibility of using flat plate collector in northern parts of Iran specially city of Rasht has been investigated in this paper. According to the high humidity in the northern parts of this country, diffuse radiation plays a more important role than direct radiation. This fact can change the results of delivered solar energy and the best tilt angle of the collector compared to the sunny cen...