Titanium dioxide and copper oxide nanoparticles are more and more widely used because of their catalytic properties, of their light absorbing properties (titanium dioxide) or of their biocidal properties (copper oxide), increasing the risk of adverse health effects. In this frame, the responses of mouse macrophages were studied. Both proteomic and targeted analyses were performed to investigate...

The formation of protective layers on copper, zinc and copper-zinc (Cu-10Zn and Cu-40Zn) alloys at open circuit potential in aerated, near neutral 0.5 M NaCl solution containing benzotriazole (BTA) was studied using potentiodynamic measurements, electrochemical impedance spectroscopy (EIS) and X-ray photoelectron spectroscopy (XPS). The addition of benzotriazole affects the dissolution of the m...

The ions released from conventional and high-copper amalgams in contact with titanium were quantitatively analyzed in a 0.9% NaCl solution at 37 degrees C when the surface area ratio of titanium/amalgam was set up as 1/10, 1/1, or 10/1. The corrosion potentials of the amalgams and titanium were measured under the same conditions. Surface analyses on the amalgams were also employed using SEM wit...

Although originally discovered in the 18th century [1], the titanium industry did not experience any significant advancement until the middle of the 20th century through the development of the gas turbine engine [2]. Since then, the aerospace sector has dominated worldwide titanium use with applications in both engines and airframe structures [3]. The highly desirable combination of properties,...

Recently, machining has been exploited as a means for producing ultra-fine grained (UFG) and nanocrystalline microstructures for various metal materials, such as aluminum alloys, copper, stainless steel, titanium and nickel-based super alloys, etc. However, no predictive, analytical or numerical work has ever been presented to quantitatively predict the change of grain sizes during machining. I...

Although titanium is considered to be a ubiquitous element as it has the 10th-highest Clarke number of all the elements, it is actually classified as a rare metal because the current refinement process for the metal is more environmentally damaging than the processes used to refine iron and aluminum. Furthermore, the principal alloying elements of titanium alloys are very expensive, owing to th...

Titanium trialuminide coating on L10-type titanium aluminide alloys represents a valuable mean to improve oxidation resistance. Selection of L12-type titanium trialuminide alloys containing Mn as a coating material is particularly attractive because of its good ductility at room temperature and good oxidation resistance at high temperature of 1273 K. However, stability of the coated titanium tr...

In dentistry, gold-based noble metal alloys have traditionally been cast into various types of dental prostheses, such as partial dentures, crowns, and bridges. More recently, less expensive dental alloys with base-metal elements, such as Co-Cr and Ni-Cr, have been used. Titanium is considered to be an attractive alternative to these traditional dental alloys because of its remarkable lack of t...

To advance the understanding of metallic materials for structural components at cryogenic temperatures, a review previous studies on mechanical properties austenitic stainless steels, titanium alloys, aluminum and copper alloys is presented herein. In particular, evaluation strength toughness balance intends to clarify key differences between these facilitate better alloy design potentially bol...

The biocompatibility of two different titanium alloys, Ti-6Al-4V ELI and Ti-5Al-2, 5Fe, and pure titanium were evaluated. The results were as follows: 1) Titanium alloys were implanted into the dorsal subcutaneous tissues of the Hartley guinea-pig for 12 weeks, immersed in calf serum or in Ringer's solution for 8 weeks. The surface changes of the titanium alloys were observed by SEM and the che...