Mg alloy AZ31 is an attractive candidate for coronary artery stents, as it possesses excellent biocompatibility in human body and good mechanical properties. However, AZ31 magnesium alloys generally have poor corrosion resistance in the body environment. This paper reports on the early stages of an investigation into the corrosion mechanism and the morphology of corrosion of AZ31 in simulated b...

The corrosion resistant coatings used conventionally are susceptible to degradation, leading to pitting corrosion. This report summarizes the corrosion resistant nature of thin films of Cu-TiO2 coated on mild steel, in different corrosion environments. Nano meter thick (100nm, 125nm, 150nm) composite coatings were coated on steel substrate by RF magnetron sputtering technique. The required targ...

Heat treatments are applied to orthodontic wires in order to relieve the stresses arising during orthodontic work. Four types of wires were heated in air, argon or vacuum environments, and cooled in the furnace or in a water bath. The susceptibility to corrosion and mechanical properties of the heat-treated wires were investigated. Heat treatment marginally increased the yield strength and elas...

An Ni2Al3 coating was prepared via the electrodeposition of nickel followed by pack aluminization. Polarization curve and electrochemical impedance spectroscopy were performed to study the room temperature corrosion behavior of the coating in a 3.5 wt. % NaCl solution. The long-term impedance of the coating was also investigated after immersion for 30 days. Results show that the Ni2Al3 coating ...

Acoustic emission with near-field detection and optical video microscope monitoring was proposed to investigate the pitting corrosion caused by a small magnesium-chloride droplet. Four types of the detected waveforms were characterized by the wavelet analysis to investigate the corrosion of work-hardened SUS304 stainless steel. After high-activity AE signals observed, the corrosion product shee...

One of the challenges faced by medical-device manufacturers is the use of short-term in-vitro data to evaluate the long-term in-vivo corrosion performance of implants. In this study, mechanically polished Nitinol wires were immersed in phosphate-buffered saline (PBS) at 37 °C for up to one week prior to performing cyclic polarization tests. Results are presented that show the effect of immersio...

In this study, the pitting behaviour of a new corrosion-resistant alloy steel (CR) is compared to that of low-carbon steel (LC) in a simulated concrete pore solution with a chloride concentration of 5 mol/L. The electrochemical behaviour of the bars was characterised using linear polarisation resistance (LPR) and electrochemical impedance spectroscopy (EIS). The pitting profiles were detected b...

Steel structures continuously exposed to offshore marine environments are prone to corrosion. This can be of major economic and perhaps of environmental significance. The risk of these scenarios occurring can be assessed using good quality data, good quality corrosion and pitting models and structural reliability assessment. Recently, improved models for the prediction of longer term corrosion ...

The corrosion behaviour of three new non-toxic titanium alloys for use as biomaterials has been investigated. The corrosion current densities of these Ti alloys have low values, indicating a passive state that is stable with time. These values were calculated by using both direct and alternate current methods. The comparison with Ti–6Al–4V, widely used as biomaterial, shows slightly lower corro...

Several surface modification techniques such as ion implantation, surface laser melting, have been employed to improve pitting corrosion resistance of stainless steel. Electropolishing is a technique in which the surface roughness is eliminated through a selective electrochemical dissolution. The effect of electropolishing on pitting corrosion of 304 stainless steel (SS) was investigated employ...