The atmospheric corrosion rate of materials changes based on different environmental conditions including time to be exposed to wet condition, relative humidity, surrounding temperature, and impurity of the air. The adhesive bond is relatively weak in conventional surface coating process which may lead the separation of these coatings and reduction of effective coating lifecycle. Some conventio...

Modern gas turbine hot sections need to be protected from elevated temperature and damaging environments. This protection starts as a typically two layer coating system, the base layer or bond coat (BC) acts as a corrosion barrier and a kind of buffer for the thermal mismatch between the base material and the second top thermally protective layer or Thermal Barrier Coating (TBC). The BC is norm...

Nickel-palladium-gold-finished terminals are susceptible to creep corrosion. Excessive creep corrosion can result in device failure due to insulation resistance loss between adjacent terminals. The mixed flowing gas test has been demonstrated to produce creep corrosion on parts with nickel-palladium-gold finished terminals. Conformal coats are often used to protect printed wiring assemblies fro...

Thermal spraying coating techniques have lately emerged as very effective surface protection technology to apply protective coatings for corrosion and wear resistance applications. These coatings have gained more importance in recent past. Advances in powder and wire production have resulted in development of various types of surface coatings with excellent wear and corrosion resistance propert...

The search for new high temperature materials has gained increasing impetus over the last ten years. Greater demands are being placed on existing materials as the environmental conditions under which they must operate become increasingly severe. In particular the trend towards optimising performance and efficiency in modern gas turbines requires the development of high strength materials with s...

nanostructured alumina thin films were coated on stainless steel by sol-gel dip coating method. in order to prevent crack formation, al2o3 films were kept in a solvent bath immediately after coating to reduce the rate of drying. effects of calcination temperature and withdrawal speed on structural properties were analyzed using xrd and sem. topography and thickness of coatings were analyzed by ...

Aluminide coatings have been studied for many years because of their excellent corrosion resistance in oxidizing, sulfidizing and carburizing environments. One of the factors that inhibits their application is a lack of sufficient data about their potential benefits. In order to address this issue, model coatings are being fabricated using a chemical vapor deposition (CVD process on ferritic (F...

Cerium conversion coatings are a potential alternative to chromium conversion coatings for improving the corrosion resistance of magnesium alloys. This study detailed the microstructure and corrosion resistance of cerium conversion coatings on AZ31 magnesium plates treated in 0.05 kmolm 3 cerium nitrate solution, with and without 0.25 kmolm 3 hydrogen peroxide. The results indicate that the cor...

the idea of smart corrosion inhibition is basis on either inhibitor consumption where it is needed or reducing harmful matrix interaction with it. in addition, applying corrosion inhibitor in a coating causes many problems such as loss of inhibition capability, coating degradation, or both. a useful technique to overcome this problem is applying of inert host systems of nanometer dimensions as ...

Severe corrosion of epoxy coated rebar in the substructure of 5 major marine bridges in the Florida Keys was detected after only a few years of construction. Corrosion occurred underneath the coating and was preceded by loss of adherence between the steel and the coating. Damage surveys of the bridges, which were built around 1980, were conducted from 1986 to 2000. Corrosion resulted in delamin...