Buck, boost, and buck-boost converters constitute large class of dc-dc converters used in practice and are interesting nonlinear dynamical systems. It has been shown earlier that various nonlinear phenomena including subharmonics and chaos can be observed in these converters. In this paper we show that with the simplifying assumption that voltage regulation is achieved in high frequency modulat...

Averaged switch approach is extended to the modeling of boundary conduction mode (BCM) dc-to-dc converters that operate at the boundary between continuous conduction mode (CCM) and discontinuous conduction mode (DCM). BCM dc-to-dc converters have smaller inductor size and reduced switching losses compared to CCM, and lower peak current compared to DCM. The large-signal BCM averaged switch model...

The DC-DC converters are widely used in photovoltaic generating systems as an interface between PV module and the load. These converters must be chosen to be able to match the maximum power point (MPP) of PV module when climatic conditions change with different resistive load values. So DC-DC converters must be used with MPPT controller in order to reduce losses in the global PV system. This ar...

MOSFET is the most commonly used devices in DC-DC power converters, and its performance is important to the prognosis and health management of power. The paper proposes a degradation analysis model for MOSFET in DC-DC power converters. A method for detecting the degradation of MOSFET is also introduced. Simulations have shown that the method can predict deterioration in the performance of MOSFE...

Consumer electronics are pervasive. It is impossible to imagine a household or office without DVD players, digital cameras, printers, mobile phones, shavers, electrical toothbrushes, etc. All these devices operate at different voltage levels ranging from 1.8 to 20 VDC, in the absence of universal standards. The voltages available are however usually 120/230 VAC at 50/60 Hz. This situation makes...

Input-series-output-parallel (ISOP) connected DC-DC converters enable low voltage rating switches to be used in high voltage input applications. In this paper, a DSP is adopted to generate digital phase-shifted PWM signals and to fulfill the closed-loop control function for ISOP connected two full-bridge DC-DC converters. Moreover, a stable output current sharing control strategy is proposed fo...

This article describes a single-input dual output (SIDO) linear-assisted DC/DC converter. Linear-assisted DC/DC converters are structures that allow to take advantages of the two classic alternatives in the design of power supply systems: voltage linear regulators and switching DC/DC converters. Thanks to the combination of a switching converter and two voltage linear regulators, the proposed S...

The photovoltaic (PV) systems exhibits nonlinear I-V characteristics and maximum power point varies with solar radiation or insolation and temperature. An intermediate pulse width modulation dc to dc converters can increase efficiency of the system by providing impedance matching between the PV system and the load and operating the PV cell arrays at their maximum power point using MPPT techniqu...

this paper presents a control strategy for fuel cell/energy storage power generation system during voltage sag conditions. the hybrid dc power sources are connected to grid using power electronic converters include dc-dc converter and grid connected voltage source inverter. the power from hybrid power sources is controlled during voltage sag by designing of control strategy for dc-dc converter....