A nonlinear detector simulation technique that can be used together with the discrete technique for a rapid radio receiver electromagnetic compatibility and electromagnetic interference (EMC/EMI) simulation up to the baseband signal processing path at the system level is proposed. The technique presented allows one to simulate an amplitude modulation (AM) detector in the large signal mode as we...

This paper introduces the vehicle fuel cell system and EMC test methods, systematically analyses research progress of standards for automotive industry system. Taking air compressor controller as an example, this study puts forward a method formulating electromagnetic compatibility standard system, gives suggestions relevant series standards.

©2009 IEEE where he was a member of the faculty in the Department of Electrical Engineering for 27 years retiring in 1998. Since 1998 he has been the Sam Nunn Eminent Professor of Aerospace Systems Engineering and a Professor of Electrical and Computer Engineering in the Department of Electrical and Computer Engineering at Mercer University in Macon, GA. He has published numerous papers on the ...

Increasing demands on electromagnetic compatibility of electronic products especially the demands on reduced emissions of microelectronic components in combination with higher complexity of electrical circuits require development of new circuit conception techniques. Due to postulation of decreased design cycles, this can only be achieved by EMC-relevant simulations during the design phase. On ...

In some industrial applications of CAN, the influence of interference becomes substantial. The paper describes measurements of the electromagnetic compatibility of CAN. The bus was submitted to standardized EMC tests and the results were evaluated so that some recommendations for designers could be given. These comprise basic design rules which increase the electrostatic discharge immunity, and...

The UWB (ultra wide band) radar output signals can be substantially affected due to electromagnetic wave propagation through obstacles (such as walls) and multipath effects, too. Multipath effects are analyzed and simulated numerically for various cases with several antenna heights and distances. Delays (due to propagation through walls and various paths of direct and reflected rays) and the ri...

Electromagnetic Interference (EMI) has long been an issue in the integrity and certification of electronic systems. Until recently design and measurement of electromagnetic compatibility (EMC) has predominantly been the focus of the back end of electronic systems manufacturing. Before a finished product could be sold on the U.S. market, the system had to be certified compliant to FCC Rules and ...

Abstract The need for electromagnetic compatibility (EMC) of electrical devices on satellites increases dramatically as the number is rapidly growing and density satellite due to their miniaturization. Thus, EMC electric propulsion system becomes an important issue a safe reliable operation satellite. In particular, this also concerns system. Since thrusters usually be operated in vacuum, dedic...

Abstract. According to the problem that the speed of electromagnetic compatibility(EMC) manual system is slow, a automatic testing system is designed for power supply line conducted emission based on general-purpose interface bus(GPIB) and LabVIEW, which actualizes a series of functions, such as signal generating, monitoring, analyzing and showing. It introduces the constituting of system, test...