The results show that the shear span ratio has significant effect on the mechanical behavior of the new-typed prefabricated shear walls, and the new-typed prefabricated shear walls have good ductility, all the ductility factors are greater than 4.0. The study also proves that the construction of the vertical joint is reasonable and its connection property is reliable. The vertical joint which c...

A revised procedure for the design of steel plate shear walls is proposed. In this procedure, the thickness of the infill plate is found using equations that are derived from plastic analysis of the strip model, which is widely accepted for the representation of steel plate shear walls. Equations are derived from a basic steel plate shear wall configuration but are shown to be conservative for ...

In this paper, a self-adaptive flange is proposed for the wind turbine shrouded by a flanged diffuser to reduce the wind loads acting on the flanged diffuser at high wind velocities. The self-adaptive flange can maintain the advantages of the flanged diffuser at wind velocities lower than the rated velocity and reduce the wind loads acting on the diffuser and blades at higher wind velocities. N...

Goals of this preliminary study are to better understand (1) earthquake performance of wood-frame shear walls carrying gravity loads, compared with walls without gravity load, and (2) performance of walls subjected to a sequence of earthquake motions, compared with walls subjected to a single earthquake. Tests with simulated earthquake ground motions were conducted on 2,440 by 2,440-mm (8 by 8-...

Strengthening of the existing seismically deficient reinforced concrete (RC) buildings is an important issue in earthquake prone regions. Addition of RC shear wall as infill or external walls into the structural system has been a commonly preferred strengthening technique since the Big Erzincan Earthquake occurred in Turkey, 1992. The newly added rigid infill walls act primarily as shear walls ...

This paper presents investigation carried out, including experimental and numerical studies, on low-rise shear-dominated brick masonry structures for the calculation of force reduction factor R. Basic experimental tests were conducted on masonry constituent materials for mechancial characterization. In-plane quasi-static cyclic tests were conducted on twelve full scale brick masonry walls, to u...

this paper provides a comparison of the maximum inter-story drifts and tip acceleration of both a 16 and 30 stories building each with different structural systems; hybrid r.c moment frame with shear walls and hybrid steel frame with shear walls and x bracing which are equipped by passive dampers. each of the building models were analyzed as fully non-linear structures for variety of dampers pl...