binaloud mountains formed during collision of iran and turan plate in the late triassic time and caused shortening of the sedimentary cover because of cimmerian and alpine orogeny. the thrust sheets with different generations formed as a results of the binalood and alborz fold- thrust belts. northeast of iran that was already south coast of the divergent margin of the paleothetys ocean at this ...

because most contaminants in water create strong interactions with hydrophobic surfaces, there are usually problems such as flux decline and pore blocking in polyethylene (pe) membranes due to irreversible adsorption of foulants on their intrinsic hydrophobic surface. therefore, in this work, attempts were made to improve the properties of pe membranes in terms of water flux and membrane foulin...

In this study, the ultrafiltration membrane for humic substance removal was prepared by blending polysulfone with a high concentration of PEG400 as additives. The influences of the additive to the fouling resistance capability and humic substances rejection of the polysulfone membrane were investigated. The addition of 35%wt of PEG400 concentration improved the pure water flux up to 200, but re...

introduction iran forms a relatively compact zone of active continental deformation resulted from the northward collision of arabia with eurasia during late cenozoic times, which is continuing to the present-day at a rate of 25 mm/yrs (from gps data). evidences of active tectonic in different parts of iran, has been studied and identified. the arid climate, low rates of erosion, and minimal veg...

This paper describes a fault detection and diagnosis scheme based on parameter estimation and presents results from its application to a cooling coil subsystem in a real building. A non-linear adaptation of the Prediction Error Forgetting (PEF), algorithm is employed to estimate the parameters of a simple, steady-state, first principles based cooling coil model. A steady-state detector is used ...

A polypropylene microporous membrane (PPMM) was fabricated by thermally induced phase separation (TIPS) method. The effects of protein size and structure as well as filtration pressure on the membrane performance and fouling mechanisms were investigated using two different proteins, bovine serum albumin (BSA) and collagen, in dead-end filtration setup. Obtained results showed that, for each pro...

This paper provides a review on the fouling mechanism and its effect onto the performance of finned tube heat exchangers in HVAC systems. Fouling tends to degrade the performance of heat exchangers by decreasing the heat transfer coefficient and increasing the air-side pressure drop across the heat exchangers. Air side fouling depends on a number of factors on the air side, including type and c...

The membrane fouling index, widely used in the reverse osmosis (RO) membrane industry, is developed mainly to assess the fouling potential of particulate matter. However, the fouling potential by organic matter should also be accurately evaluated as the productivity loss by organic fouling is often more severe than particle fouling, despite its low concentration in feed water. This study was pe...

Crude oil fouling of the equipment surfaces is a troublesome issue which leads to operating difficulties, economic penalties, increased environmental impacts, and health and safety hazards in petroleum industry. With a rough estimation, a minimum cost of equal to 4 million barrels of oil/year is required to be invested to offset the costs of crude oil fouling in Pre-heat Trains of Iranian oil r...

The combined fouling during ultrafiltration (UF) of surface water pretreated to different extents was investigated to disclose the roles of polysaccharides, proteins, and inorganic particles in UF membrane fouling. Both reversible and irreversible fouling decreased with enhanced pretreatment (biologically active carbon (BAC) treatment and sand filtration). The sand filter effluent fouled the me...