The dual fuel engines at part loads inevitably suffer from lower thermal efficiency and higher carbon monoxide and unburned fuel emission. This work is carried out to investigate combustion characteristics of a dual fuel (dieselgas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors developed software in ...

To overcome the imbalance between spindle heat generation and dissipation caused 11 by existed spindle cooling strategies, this paper develops a power matching based cooling 12 strategy for motorized spindle unit. Firstly, heat generation, conduction and dissipation are 13 considered for the modeling of spindle structural heat exchange. This modeling methodology 14 conveys that an operating mot...

This paper describes an experimental investigation of acoustically forced lean premixed turbulent bluff-bodystabilised flames in an enclosure short enough so that no coupling of the combustor downstream acoustics occurred for the frequencies studied here, which allows an unambiguous examination of the flame response to inlet velocity fluctuations. Special emphasis was placed on the amplitude de...

Rapid uniform cooling of the heart is the most important requirement of any method using local hypothermia for protection of the myocardium during open intracardiac surgery. We report the construction and operation of a recirculation cooling circuit comprising a reservoir, pump, and heat-exchanger for this purpose. It is operated by the perfusionist and can deliver up to 1 litre of fluid per mi...

A recirculation microbial desalination cell (rMDC) was designed and operated to allow recirculation of solutions between the anode and cathode chambers. This recirculation avoided pH imbalances that could inhibit bacterial metabolism. The maximum power density was 931±29mW/m(2) with a 50mM phosphate buffer solution (PBS) and 776±30mW/m(2) with 25mM PBS. These power densities were higher than th...

Several approaches to numerical modelling of liquid droplet heating and evaporation by convection and radiation from the surrounding hot gas are discussed. The finite thermal conductivity of liquid, recirculation in droplets, and time dependence of gas temperature and the convection heat transfer coefficient are taken into account. For the constant and almost constant convection heat transfer c...

A numerical study on the influence of forward-facing cavity length upon forward-facing cavity and opposing jet combined thermal protection system (TPS) cooling efficiency under hypersonic flow is conducted, by means of which the flow field parameters, heat flux distribution along the outer body surface are obtained. The numerical simulation results are validated by experiments and the cooling e...

The effect of swirling on the flow characteristics of tubes with sudden expansion is experimentally examined by 3D particle image velocimetry(PIV) technique to determine velocity profiles. The swirling flow of water in sudden 1:2 axisymmetric expansion has been previously studied within a horizontal round tube. A tangential slot is used as a swirl generator for swirling flow, whereas a honey co...

Heat pipes have immense potential in the future of thermal management in electronic devices. As a passive device, they rely solely upon capillary forces to recirculate the coolant from the condenser to the evaporator via a wicking structure. In intermediate temperature heat pipes the limiting factor for heat removal is the capillary limit, which indicates the maximum recirculation rate that the...