In the present study, the high viscosity of the jatropha curcas oil was decreased by preheating. The effect of fuel inlet temperature on performance of diesel engine is evaluated. A single cylinder, four stroke, constant speed, air cooled, direct injection diesel engine developing a power output of 3.7 kW at 1500 rev/min typically used in agricultural sector was tested using neat jatropha oil a...

A three-phase fixed-bed reactor for selective hydrogenation of butadiene in liquid phase with toluene as solvent is modeled using published kinetics. Thermodynamic and transport properties are estimated from models and correlations available in the literature. The model incorporates momentum and energy balances and mass transfer resistances. The results show that use of toluene increases the yi...

The removal of CO2 through chemical absorption in a bench-scale spray dryer absorber was investigated experimentally using the lime slurry as absorbent. The effect of important operating parameters on CO2 removal efficiency has been investigated; in selected ranges of operating parameters, increasing gas inlet temperature and absorbent concentration lead to permanent efficiency decline, increas...

Gas turbines play an important role in supplying power for the country especially in peak electricity load. The main disadvantages are the turbines, they produce large changes are a result of climate change. However, in times of peak electricity grid and at the same time warm months, can produce gas turbines under the effect of ambient temperature, the amount of reduced considerably. The method...

an s-curve to describe the gradual transition between exhaust pressure and intake or inlet pressure. The start of compression, which marks the end of the intake process, does not necessarily occur at the same time as the close of the intake valve (IVC). The intake valve closes after bottom center (BC) while the volume in the cylinder is decreasing. The engine speed determines the point at which...

biofiltration of triethylamine (tea) vapor used as a catalyst in casting operations was evaluated in this study. the unit consisted of a 6-l three-stage biofilter containing a mixture of compost and wood chips (40:60 v/v) as the filter medium. seed microbial population from municipal activated sludge was acclimated for a period of three weeks prior to the actual experimental runs. in the startu...

A numerical model was developed to simulate vapor deposition in high-pressure chemical vapor-deposition reactors, under different conditions of pressure, temperature, and flow rates. The model solved for steady-state gas-phase and heterogeneous chemical kinetic equations coupled with fluid dynamic equations within a three-dimensional grid simulating the actual reactor. The study was applied to ...

In the current study, reduction of nitrogen oxide from exhaust gas in the presence of NH3 as reductant on selective catalytic reductant (SCR) impregnated catalytic converter was simulated using Comsol© software. Mass transfer (one-dimensional) and heat transfer (three-dimensional) governing equations were taken into account to model the unsteady state behavior of the catalytic converter. Modeli...