In this paper, the metal matrix composites containing 22 wt % Cr, 2.5 wt % C and 2 to 16  volume percent TiC were processed by solidifying Fe-Cr-Ti-C in which precipitation of titaniumcarbide and chromium carbide occurred. The microstructure and abrasion resistance of in-situ synthesized composites were compared with the unreinforced high chromium white cast iron (HCWCI) containing 22 w. t. % C...

Fabrication and characterization of aluminum matrix composites containing different volume fractions of Ni3Al powder (5-40 Vol%) were investigated. Ni3Al powder was produced by mechanical alloying of elemental nickel and aluminum powder mixture. Al-Ni3Al composite parts were prepared using a powder metallurgy route involving two stages Al and Ni3Al powder mixtures were first compacted under 500...

This paper studies the fracture behaviour of unidirectional carbon fibre reinforced carbon matrix composites and its relation with the type of fibre-matrix interface developed in the composite. Model unidirectional carbon-carbon composites were prepared using the same type of fibre and different pitches as matrix precursors. These included both commercial pitches and synthesized in the laborato...

The potential use of carbon fibre laminate composites is limited by the weak out-ofplane properties, especially delamination resistance. The effect of incorporating titanium carbide to the mesophase pitch matrix precursor of carbon fibre laminate composites on interlaminar shear strength is studied both on carbonised and graphitised composites. The presence of titanium carbide modifies the opti...

Bi-layer hybrid biocomposites were fabricated by hand lay-up technique by reinforcing oil palm empty fruit bunch (EFB) and jute fibre mats with epoxy matrix. Hybrid composites were prepared by varying the relative weight fraction of the two fibres. The physical (void content, density, dimensional stability), and chemical resistant properties of hybrid composites were evaluated. When the jute fi...

The authors describe a technique for melt infiltration casting of composites with a metallic-glass matrix. We made rods 5 cm in length and 7 mm in diameter. The samples were reinforced by continuous metal wires, tungsten powder, or silicon carbide particulate preforms. The most easily processed composites were those reinforced with tungsten and carbon steel continuous wire reinforcement. The Zr...

Carbon fiber-reinforced multi-layered pyrocarbon-silicon carbide matrix (C/C-SiC) composites are widely used in aerospace structures. The complicated spatial architecture and material heterogeneity of C/C-SiC composites constitute the challenge for tailoring their properties. Thus, discovering the intrinsic relations between the properties and the microstructures and sequentially optimizing the...

2.13.

Effects of nutshell fiber loadings of 30 wt.% and MCC loadings up to 15 wt.% on some properties of high-density polyethylene composites (HDPE) were investigated. The composites were manufactured by a single screw extruder and injection molding. The experimental composite samples were tested for their mechanical performance including tensile strength, tensile modulus, flexural strength, flexural...

A maximal product of stiffness and viscoelastic damping (E tan d), a figure of merit for damping layers, is desirable for structural damping applications. Particulate-reinforced metal–matrix composites were prepared by ultrasonic agitation of the melt and composed of the zinc–aluminum (ZnAl) alloy Zn80Al20 (in wt%) as the lossy matrix and SiC or BaTiO3 as the particulate reinforcements. ZnAl–Si...