In this paper, 2wt.% Fe doped TiO2 nanopowder was prepared by a combination of sol-gel and mechanical alloying methods. The mechanical alloying of Fe powder with Ti(OH)4 gel produced from the sol-gel method was used to produce Fe doped TiO2 nanopowder. The synthesized samples were characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM) and diffuse reflectan...

Ni and Cu elemental powder mixtures containing 25, 50, and 75% at Cu were subjected to mechanical alloying in a planetary ball mill under various milling times. Structural evolution was analyzed by means of X-ray diffraction and scanning electron microscopy. Experimental results indicated that nanostructured solid solution alloy powders having homogeneous distribution of Ni and Cu were formed b...

Under mechanical milling conditions, direct reductive benzylizations of malononitrile and 4-methylaniline by aromatic aldehydes were achieved using a Hantzsch 1,4-dihydropyridine as the reductant.

The intermetallic compound AlFe in its ordered B2 phase has been ground under Ar in a ball-milling device. The system evolution under mechanical work has been examined as a function of time of milling by x-ray diffraction, transmission Mössbauer spectroscopy, and differential scanning calorimetry. Short and long range disorder was observed. The evolution of the long range order parameter with m...

Point defect concentrations in milled samples of stoichiometric FeAl were obtained by Mšssbauer measurements. Mšssbauer spectra consisted of a single absorption dip with broadening attributed to unresolved hyperfine interactions. A local environment model was used to analyze spectra that allowed for defect-induced changes in monopole interactions at Fe probe atoms due to elementary defects in t...

Oxone is found to be an effective oxidant for the oxidative amidation of aldehydes with anilines to furnish amides in a one-pot process under mechanical milling conditions.

The effect of milling time on the morphology, microstructure, physical and mechanical properties of pure Al-5 wt % Al₂O₃ (Al-5Al₂O₃) has been investigated. Al-5Al₂O₃ nanocomposites were fabricated using ball milling in a powder metallurgy route. The increase in the milling time resulted in the homogenous dispersion of 5 wt % Al₂O₃ nanoparticles, the reduction of particle clustering, and the red...

The solid state reactions and structural evolution in nanocrystalline FePt powders during mechanical ball milling at 77 K and subsequent annealing have been investigated. Above 310 °C the formation of L10 FePt is observed. As the milling time increases, the enthalpy evolved during the transformations is reduced, whereas the corresponding activation energy increases. For accelerating the orderin...

The correlation between the microstructure of Ag-C, Ag-WC-C and AgWC composites and their switching properties was investigated. Two methods were used to manufacture the starting powder mixtures, namely classical milling and mechanical alloying . The arc erosion, contact resistance and welding forces of the contact materials obtained by different methods were measured using model devices. This ...

For microfabrications of biochips with micro fluidic channels, a large number of microfabrication techniques based on silicon or glass-based Micro-Electro-Mechanical System (MEMS) technologies were proposed in the last decade. In recent years, for low cost and mass production, polymer-based microfabrication techniques by microinjection molding and micro hot embossing have been proposed. These t...