Purpose: of this paper is the effect of the soft annealing of initial microstructure of the 6Mn16 steel on the kinetics of the austenite formation during next intercritical annealing. Design/methodology/approach: Analytical TEM point analysis with EDAX system attached to Philips CM20 was used to evaluate the concentration of Mn, Ni and Cr in the microstructure constituents of the multiphase ste...

Intra-granular Acicular Ferrite (IAF), as one of the most well-known desirable microstructure of ferrite with a chaotic crystallographic orientation, can not only refine the microstructure and retard the propagation of cleavage crack but also provide excellent combination of strength and toughness in steel. The effect of adding cerium on microstructure and controlling proper cerium-based inclus...

in this study, the effect of cold rolling process on the microstructure and texture evolution in 1wt. % si non-orientedelectrical steel was investigated. for this purpose, all samples were processed through single-stage hot rolling at1100 ° c and two-stage cold rolling (cross rolling and unidirectional rolling) with intermediate annealing at 650 °cfor 35 seconds. finally, all of them were fully...

Abstract: Plasma electrolytic oxidation (PEO) technique was used to prepare ceramic coatings on the casted aluminum alloys containing ~5 and ~9.5 wt.% Mg. The applied voltage was controlled at 450V and 550V for evaluating the effect of this main parameter, as well as, magnesium content of the substrate on the microstructure and electrochemical corrosion behavior after PEO treating. The results ...

Seeding effects on the microstructure and mechanical properties of single-phase Ca-α-SiAlON ceramics have been investigated. Whereas a small amount of seeds can transform the microstructure from one of fine equiaxed grains to one consisting of many needle-like grains, the highest fracture toughness of 8 MPa . m1/2 is not reached until 8% seeding. This contrasts with the much higher seed efficie...

The effects of a third element, namely silver, copper, zinc, or antimony, on the microstructure and mechanical properties of eutectic tin-bismuth (Sn–Bi) solder were investigated. The investigation showed that, except for zinc, the addition of a trace amount of the third element improves the ductility of the Sn–Bi solder owing to the formation of a fine, homogeneous ternary eutectic microstruct...

Microstructure plays an essential role in determining the properties of crystalline materials. A widely used method to influence microstructure is the addition of nucleating agents. Observations on films formed from clay-polymer blends indicate that particulate additives, in addition to serving as nucleating agents, may also perturb crystal growth, leading to the formation of irregular dendriti...