Submitted: Jan 13, 2013; Accepted: Feb 26, 2013; Published: Aug 18, 2013 Abstract: This paper presents the design and performance evaluation of a modified complementary energy path adiabatic logic (MCEPAL) circuit. A simulative investigation on the proposed MCEPAL based, multiplexer, JK flip flop and 3 bit counter has been done using VIRTUOSO SPECTRE simulator of cadence in 0.18μm UMC technolog...

In this paper, five new multiplexer-based architectures for 1 -bit full adder circuit designs are proposed. Following these architectures, various full adder circuits can be built through different circuit implementations of multiplexers. For instance, in this paper, we demonstrate that by substituting each multiplexer with two transmission gates, a set of new full adder circuits are ready to b...

This paper aims at reducing power and energy dissipation in Transmission Gate Logic (TGL) Multiplexer CMOS circuits comprise of reducing the power supply voltages, power supply current and delay with economical charge recovery logic. This paper designs an 8:1 Multiplexer with CMOS Transmission Gate Logic (TGL) using the Power Gating Technique, which reduces the leakage power and leakage current...

The Integrated Circuit Technology(IC) is growing day by day to improve circuit performance. Quantum dot cellular automata (QCA) is one of the noval technology in nano electronics, introduced to overcome the scaling limitations takes place in CMOS Technology. This technology is suitable for development of ultra-dense low-power high-performance digital circuits. In this paper we are implementing ...

Recent studies have shown that the superposition of packet sequences generated by packetized voice sources with speech detection exhibit high burstiness due to inherent correlations between successive interarrival times in the superposition stream. In a packet voice multiplexer without bit dropping, these correlations tend to cause significantly larger queueing delays and packet losses than wou...

Abstract A technique of differential rectification is proposed for three-phase coil based inductive angle sensors so that the amplitude difference between any two amplitudes coils output further signal processing. 3-to-6 multiplexer, a low pass filter, and 6-to-2 multiplexer are designed technique, which used rectification, turning rectified signals into DC levels, transmitting levels to rectif...

Abstract A novel plasmonic unidirectional coupler and its extension to a multiplexer/demultiplexer are proposed simulated. The structure can be etched adjacent metal-insulator-metal (MIM) waveguides which result in considerable reduction footprint of optical signal processing systems. Simulated results show very good agreement with design. Extinction ratio (ER) more than 11 dB was achieved for ...