in this paper, the performance evaluation of a two-way hybrid photovoltaic/thermal (pv/t) solar collector was analytically and experimentally carried out. mathematical expressions for operating parameters in glass to glass and glass to tedlar pv/t solar collectors were developed and experimentally validated by a glass to tedlar pv/t solar collector system. also the influence of air flow rate on...

The tests were carried out with the spark timing adjusted to the maximum brake torquetiming in various equivalence ratios and engine speeds for gasoline and natural gas operations. In thiswork, the lower heating value of gasoline is about 13.6% higher than that of natural gas. Based on theexperimental results, the natural gas operation causes an increase of about 6.2% brake special fuelconsumpt...

• The actual flow rate is constant for the outlet pressure range of 35.30 psig to as low as a complete vacuum. The flow rate can be obtained from the charts on pages 16-18; e.g. for an orifice of .010" diameter and with 80 psig inlet pressure, the choked flow rate is 8.4 scfh (page 16). This flow rate will be constant for all outlet pressure conditions between 35.30 psig and full vacuum. 0 1 .5...

Spray drying is a common drying technique in food industries to convert liquid to powder form. A good understanding on the dynamic behavior of the process is important to ensure proper control. The aim of this study is to develop empirical models for spray drying of whole milk powder and orange juice powder. A preliminary study on the effect of several inputs such as inlet air temperature, feed...

The effect of the volume flow rate of the heat transfer fluid (air) on the thermal parameters of the solar air collector with a single air pass without using fins under the absorbing plate have been investigated experimentally and theoretically. We use a new design of solar air collector which aims to optimize these parameters in the region cited above. Our solar air collector was realized at t...

Gas turbine systems with wet compression have a potential for future power generation, since they can offer a high efficiency and a high specific power with a relatively low cost. In this study influence of ambient condition on the performance of the wet compression process is investigated with a non-equilibrium analytical modeling based on droplet evaporation. Transient behaviors of droplet di...

A solution to the inverse heat transfer problem (IHP) occurring in steam pipelines is presented paper. The transient temperature at pipeline inlet was determined from measured outlet. Temporary changes of turbine are set by manufacturer and result conditions safe starting maintaining high durability its components. boiler start-up should be carried out so that time-temperature outlet equal usin...