PZT-Poly(vinylidene fluoride) composites were prepared by hot-pressing method. Before addition, PZT particles were firstly modified with two different coupling agents. The micromorphology, microstructure, dielectric properties, and piezoelectric properties of the composites were characterized and investigated. Results indicated that PZT particles were homogeneously dispersed in the PVDF matrix ...

This paper provides a quantitative comparison and explores the design space of lead zirconium titanate PZT –only and PZT-on-silicon length-extensional mode resonators for incorporation into radio frequency microelectromechanical system filters and oscillators. We experimentally measured the correlation of motional impedance RX and quality factor Q with the resonators’ silicon layer thickness tS...

Pb(Zr0.52Ti0.48)O3 (PZT) nanotubes with diameters of 80–100 nm and a wall thickness of 15–20 nm were prepared by sol–gel template technique and using multi-walled carbon nanotubes (MWCNT) as sacrificial templates. The coating process of MWCNT with PZT precursor sol and removal of the carbon nanotubes by an interrupt heat treatment were discussed and studied by Raman spectroscopy. Simultaneous t...

This paper reviews deposition, integration, and device fabrication of ferroelectric PbZrxTi1−xO3 (PZT) films for applications in microelectromechanical systems. As examples, a piezoelectric ultrasonic micromotor and pyroelectric infrared detector array are presented. A summary of the published data on the piezoelectric properties of PZT thin films is given. The figures of merit for various appl...

A post-tensioning tendon duct filled with grout can effectively prevent corrosion of the reinforcement, maintain bonding behavior between the reinforcement and concrete, and enhance the load bearing capacity of concrete structures. In practice, grouting of the post-tensioning tendon ducts always causes quality problems, which may reduce structural integrity and service life, and even cause acci...

If the nonlinearity of the motion of a piezoelectric transducer (PZT) can be described as a quadratic function, the integrated intensity of one frame in phase shift interferometry can be calculated using the Fresnel integral. For a PZT with smaller nonlinearity, the rms phase error is almost linearly proportional to the quadratic coefficient The effects of PZT nonlinearity on the three- and the...

Lead zirconate titanate (PZT) nanofibers are obtained by electrospinning a sol-gel based solution and polyvinyl pyrrolidone (PVP) polymer, and subsequent sintering of the electrospun precursor fibers. The PVP content of the precursor solution is critical in the formation of the fully fibrous mats. Scanning electron microscope (SEM) is used to examine the morphology of the precursor fibers and a...

Lead zirconate titanate (Pb(Zr1−xTix)O3 or PZT) ferroelectric ceramics have been widely used in transducers, actuators, and sensors, since they posses high dielectric and piezoelectric properties with a relatively high temperature of operation. Commercially used PZT ceramics are always modified by different dopants and are divided into the “soft” (donor doped) and “hard” (acceptor doped) groups...

In this study, we fabricated piezoelectric energy harvesters composed of lead-free (K,Na)NbO3 (KNN) thin films and compared the power generation performance with PZT-thin film energy harvesters. Both of the piezoelectric thin films were deposited on Pt/Ti/Si cantilevers by rf-sputtering. The KNN and PZT thin films had perovskite structure, and showed the relative dielectric constants of 744 and...

We demonstrate a water-immersible thin film lead zirconate titanate, Pb(Zr,Ti)O3, [PZT] actuator, without special passivation layer, towards in-vivo or in-vitro scanning probe microscope (SPM) measurements of living cells in water or biological fluids. In order to be water-immersible, the electrodes need to be electrically insulated and the piezoelectric layer needs to be protected against dire...