The aim of this study was to investigate the flexural behavior of engineered cementitious composites (ECCs) reinforced by cellulose pulp (CP) and cellulose microfibers (CMF). The reinforcements were obtained from chemical-mechanical treatments of Kraft paper and used in ECC mix design. Results showed that cement reinforced by CP exhibited a strain-hardening behavior in the three-point bending t...

limit to the tension reinforcement ratio in flexural high strength reinforced concrete (hsrc) members isbased on the requirement that tension failure as sufficient rotation capacity are ensured at ultimate limit state.however, the provisions for the total amount of longitudinal reinforcement ratio ( and ) are not associated withany rational derivation. in this paper, a quantitative measure to e...

limit to the tension reinforcement ratio ( ρ) in flexural high strength reinforced concrete (hsrc) members is based on the requirement that tension failure as sufficient rotation capacity are ensured at ultimate limit state. however, the provisions for the total amount of longitudinal reinforcement ratio ( ρ and ρ’) are not associated with any rational derivation. in this paper, a quantitative ...

This paper introduces a finite element scheme and a systematic calibration approach for masonry infilled RC frames. The modeling scheme combines the smeared crack approach with discrete crack elements to allow for the opening of diffused flexural and dominant shear cracks. It is, therefore, able to capture the nonlinear material behavior and the interaction of the infill wall with the bounding ...

a large number of bridges and buildings that are currently used, are made of slabs with opening. some of these buildings and bridges have been severely damaged because of natural disasters such as earthquake, storm and other effects such as materials fatigue and alkaline and corrosive agents. therefore, retrofitting and strengthening of these structures is essential and affordable. in this rese...

the incorporation of boehmite nano-particles and its effects on the mechanical properties and bond strength of an experimental dental adhesive were studied.an adhesive solution containing ethanol, bis-gma, tmptma, hema and photo-initiator system (camphorquinone and dmaema) was prepared. silanized boehmite nano-particles were incorporated into the adhesive in different concentrations of 0, 0.2, ...

Motile cilia and flagella are whiplike cellular organelles that bend actively to propel cells or move fluid in passages such as airways, brain ventricles, and the oviduct. Efficient motile function of cilia and flagella depends on coordinated interactions between active forces from an array of motor proteins and passive mechanical resistance from the complex cytoskeletal structure (the axoneme)...

Plastic hinge models are widely used in earthquake engineering to predict the load-deformation relationships of reinforced concrete members. For the seismic assessment of bridges, it is appealing to use those relatively simple models if the response is predicted with sufficient accuracy. The applicability of these models to wall-type bridge piers with weak seismic detailing is examined. Flexura...

This paper presents the influence of polyolefin fiber on flexural and shear attitude flat slabs. Three slab sets (80 cm × 80 cm) were tested, each with a thickness 10 cm. In first set (S1), effect content behavior was considered. Therefore, four specimens cast, one which considered as control specimen no content, while other three included fibers at 0.5, 1, 1.5 percent total concrete volume. Th...