geometrically nonlinear governing equations for a plate with linear viscoelastic material are derived. the material model is of boltzmann superposi¬tion principle type. a third-order displacement field is used to model the shear deformation effects. for the solution of the nonlinear governing equations the dynamic relaxation (dr) iterative method together with the finite difference discretizati...

The rheology of bubble-bearing suspensions is investigated through a series of three-dimensional boundary integral calculations in which the effects of bubble deformation, volume fraction, and shear rate are considered. The behaviour of bubbles in viscous flows is characterized by the capillary number, Ca, the ratio of viscous shear stresses that promote deformation to surface tension stresses ...

Metamorphic and various intrusive rocks in the Urmia area are located in a transpressed active continental margin. These complexes in the Zagros orogen were deformed during an oblique convergence scenario between the Arabian and Sanandaj–Sirjan blocks in NW Iran. The Urmia area contains both NW-SE striking dextral strike-slip and SW verging NE dipping ductile reverse shear fabrics. Ductile shea...

Inelastic deformation of metallic glasses occurs via slip events with avalanche dynamics similar to those of earthquakes. For the first time in these materials, measurements have been obtained with sufficiently high temporal resolution to extract both the exponents and the scaling functions that describe the nature, statistics and dynamics of the slips according to a simple mean-field model. Th...

The deformation of red blood cells in microvessels was investigated numerically for various vessel diameters, hematocrits, and shear rates. We simulated blood flow in circular channels with diameters ranging from 9 to 50 μm, hematocrits from 20% to 45%, and shear rates from 20 to 150 s(-1) using a particle-based model with parallel computing. The apparent viscosity predicted by the simulation w...

In a Z-core sandwich panel, the shear stiffness of the sandwich panel in the weak direction which is perpendicular to the placement of the Z-cores is much smaller than the bending stiffness because the hollow section between the two facing plates cannot sustain shear action. Because of this fact, the shear deformation of a Z-core sandwich panel under bending in the weak direction cannot be igno...

We have performed molecular-dynamics simulations of atactic polystyrene thin films to study the effect of shear rate, pressure, and temperature on the stress-strain behaviour, the relevant energetic contributions and non-affine displacements of polymer chains during constant-shear deformation. Under this deformation sliding motion is observed at high shear rates between the top substrate and to...

Shear stresses are always present during quasi-static strain imaging, since tissue slippage occurs along the lateral and elevational directions during an axial deformation. Shear stress components along the axial deformation axes add to the axial deformation while perpendicular components introduce both lateral and elevational rigid motion and deformation artifacts into the estimated axial and ...

Result and Conclusion: The results show that strength of horizontal bars has a little influence on the hysteretic behavior and the deformation ability. While the decrease of the strength of horizontal bars can increase the yield displacement and the peak displacement of the hollow slab shear walls. The hollow slab shear wall structure has good deformation capacity, and the brittle shear failure...

Frictional and frictionless granular materials in a split-bottom ring shear cell geometry show wide shear bands under slow, quasi-static deformation. Here, the differences between frictional and frictionless materials are elaborated using discrete element simulations (DEM). Several continuum fields like the density, the velocity field, the deformation gradient and the stress are used here for c...