The large-amplitude nonlinear shear rheology of polymer melts confined between strongly adsorbing surfaces (parallel plates of mica) was studied as a function of strain, frequency, and thickness of the polymer films. The shear strains varied from less than 0.1 (linear response) to over 30 (at which the film structure was strongly modified by the imposed shear). The measurements employed a surfa...

We use shear transformation zone (STZ) theory to develop a deformation map for amorphous solids as a function of the imposed shear rate and initial material preparation. The STZ formulation incorporates recent simulation results [T. K. Haxton and A. J. Liu, Phys. Rev. Lett. 99, 195701 (2007)] showing that the steady state effective temperature is rate dependent. The resulting model predicts a w...

The potential energy landscape of a flowing metallic glass is revealed using the activation-relaxation technique. For a two-dimensional Lennard-Jones system initially deformed into a steady-state condition through quasistatic shear, the distribution of activation energies is shown to contain a large fraction of low-energy barriers, consistent with a highly nonequilibrium flow state. The distrib...

This paper reports the first study on the large amplitude oscillatory shear flow for magnetic fiber suspensions subject to a magnetic field perpendicular to the flow. The suspensions used in our experiments consisted of cobalt microfibers of the average length of 37 μm and diameter of 4.9 μm, dispersed in a silicon oil. Rheological measurements have been carried out at imposed stress using a co...

We report x-ray photon correlation spectroscopy experiments on a concentrated nanocolloidal gel subject to in situ oscillatory shear strain. The strain causes periodic echoes in the speckle pattern that lead to peaks in the intensity autocorrelation function. Above a threshold strain that is near the first yield point of the gel, the peak amplitude decays exponentially with the number of shear ...

We investigate the mechanical responses of dense granular materials, using a direct shear box combined with simultaneous acoustic measurements. Measured shear wave speeds evidence the structural change of the material under shear, from the jammed state to the flowing state. There is a clear acoustic signature when the shear band is formed. Subjected to cyclic shear, both shear stress and wave s...

The material behavior of ligament is determined by its constituents, their organization and their interaction with each other. To elucidate the origins of the multiaxial material behavior of ligaments, we investigated ligament response to shear loading under both quasi-static and rate-dependent loading conditions. Stress relaxation tests demonstrated that the tissue was highly viscoelastic in s...

Cilia are motile biological appendages that are driven to bend by internal shear stresses between tubulin filaments. A continuum model of ciliary material is constructed that incorporates the essential ciliary constraints: (1) one-dimensional inextensibility of filaments, (2) three-dimensional incompressibility, and (3) shear strain only along filaments. This hypothetical ciliary material combi...

This paper studies the propagation of disturbances in an initially stress-free elastic circular rod. Starting from the Mindlin-Hermann equations, we derive a fourth-order partial differential equation as the governing equation for small axial-radial deformations in a rod composed of an incompressible material. Then, we consider an initial-value problem with an initial singularity in the shear s...

Field observations of major earthquake fault zones show that shear deformation is often confined to principal slipping zones that may be of order 1–100 μmwide, located within a broader gouge layer of order 10–100 mm wide. This paper examines the possibility that the extreme strain localization observed may be due to the coupling of shear heating, thermal pressurization, and diffusion. In the ab...